Automatic Technology Syncro ATS-2 Manuel d'utilisation rapide - Page 5
Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation rapide pour {nom_de_la_catégorie} Automatic Technology Syncro ATS-2. Automatic Technology Syncro ATS-2 6 pages. Sectional door openers
Imprimer la page
6 . 0 T R O U B L E S H O O T I N G
Main Light = Service / Warning Indicator:
Requirements for a service and user warnings are indicated after
operation by the main light repeatable flashing OFF a number of
times followed by a pause.
The below table identifies the issues and remedies
1
Normal operation (door is fully open)
2
PE is precenting door from
moving
Not Available
3
4
Wireless PE battery is low
5
Not Available
6
Maintenance is due after
pre-set number of cycles.
7
Standby battery is faulty
Door was obstructed
8
9
Motor overloaded or
stalled
10
Unit running on battery
power (Only available with
ATS-3)
Issue
Remedy
Clear away any obstructions.
Test Door. If unable to move
the door and suspect beam is
faulty, enter Safety Beam
Emergency Close by pressing
and holding a pre-coded
transmitter button until the
door closes.
-
Change PE Battery
-
Contact dealer to arrange
service.
Contact 1300 769 850 within
Australia for assistance.
Clear away any obstructions
and test door opens/closes
correctly. (if the door is
damaged, contact a door
professional)
Contact dealer to arrange a
door service.
Main light will flash (3) three
times at the start of the cycle to
indicate the opener is running
from battery backup and 10
flashes at the end of cycle.
Check power supply.