Activeforever Conversion II 9003 Manuel du propriétaire - Page 8

Parcourez en ligne ou téléchargez le pdf Manuel du propriétaire pour {nom_de_la_catégorie} Activeforever Conversion II 9003. Activeforever Conversion II 9003 20 pages. Conversion ii 9003 trainers

Imprimer la page

ASSEMBLY INSTRUCTIONS

STEP 11

NOTE:

The RIGHT PEDAL(41) has R stamped on the end of the pedal shaft. The RIGHT PEDAL(41) has

right hand threads and is tightened by turning clockwise. The LEFT PEDAL(39) has L stamped on

the end of the pedal shaft. The LEFT PEDAL(39) has left hand threads and is tightened by turning

counter clockwise.

Thread the RIGHT PEDAL(41) onto the RIGHT CRANK(37) located at inside of the CRANK COVER(35) as

shown. Tighten the pedal securely. Select the RIGHT PEDAL STRAP(42) which has R marked on the

bottom side of the strap. Snap the three hole end onto the inside edge of the RIGHT PEDAL(41). Snap the

other end onto the outside edge of the RIGHT PEDAL(41) with the R mark on the bottom of the RIGHT

PEDAL STRAP(42). Select adjustment holes which allow your foot to be easily removed from the pedals.

Do the same way to attach the LEFT PEDAL(39) onto the LEFT CRANK(36) and snap the LEFT PEDAL

STRAP(40) onto the LEFT PEDAL(39).

STEP 12

Refer to the inset drawing. Plug the PULSE SENSOR WIRE(73) into the socket of PULSE COIL WIRE(74)

located on the SEAT CARRIAGE(64). Plug the PULSE COIL WIRE(74) into the socket of PULSE

CONNECTION WIRE(75) located on the bracket on the MAIN FRANE(1).