Dynalabs DYN-C-1002-LN Manuel du produit - Page 7
Parcourez en ligne ou téléchargez le pdf Manuel du produit pour {nom_de_la_catégorie} Dynalabs DYN-C-1002-LN. Dynalabs DYN-C-1002-LN 8 pages.
Imprimer la page
All rights reserved. Reproduction or issue to third parties in any form whatsoever is not permitted without written authority from the proprietors.
3) Operation and Installation
3.1) General
The general sensor connector configuration is given below;
Cable Code/Pin Configuration:
• Red
: V +
• Black
: Ground
• X : Yellow : Signal(+)
Blue : Signal(-)
WARNING
Never connect the power supply and/or the power ground to yellow and/or blue
cables.
Never connect the power supply to the power ground. Always use a clean power
source and check the voltage range.
4) Sensor Static Calibration Verification
Using gravity, voltage values are measured in the + and – gravity directions, providing a value
of ±1 g. The measurement should be made as follows;
When the sensitivity value of 1000LN series sensors is used
with the data acquisition system, the sensor shows +1 g
with the effect of gravity in the direction of the arrow sign.
When the sensor is in the opposite direction of the arrow,
it shows -1 g with the effect of gravity.
Using gravity, the voltage values that provide 1 g in the + and - directions are measured and
compared with the catalog value. The calibration value should be close to the catalog value with
10% tolerance. Sensor catalog sensitivity values are given in Table 1.
Power supply voltage +5 to +20 VDC
Power GND
Positive, analog output voltage signal for differential mode.
Negative, analog output voltage signal for differential mode.
7