HID OMNIKEY eBase 5025 Manuel d'installation - Page 4
Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} HID OMNIKEY eBase 5025. HID OMNIKEY eBase 5025 6 pages.
Imprimer la page
OMNIKEY Smart Card Reader
Regulatory
CAUTION: Any changes or modifications to this device not explicitly approved by manufacturer
could void your authority to operate this equipment.
ATTENTION: Tout changement ou modification de cet appareil sans approbation explicite
du manufacturer vous enlève les droits d'usage de cet équipement.
FCC (All Readers)
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
Product Radio Certifications
The OMNIKEY 5022 CL and 5127CK MINI Module were tested under the FCC rules and Industry
Canada rules for a Modular Approval and therefore the following shall apply: (reference below
FCC/IC IDs)
• Provided that the Antenna and tuning network have not been changed in any way, the Final
Product label may contain the HIID Global FCC ID. Provided no other radio devices exist
within the final assembly. The end integrator may use these ID's, as long at the original HID
Global Label is visible.
• FCC ID: JQ6-OK5022CL or IC ID: 2236B-OK5022CL
• FCC ID: JQ6-OK5127CKMINI or IC ID: 2236B-OK5127CKMINI
• The End User/Manufacturer, will not need to repeat the intentional emissions testing (actual
radio certification), however the un-intentional emissions testing will need to meet the FCC
and IC requirements with the module installed into the final assembly or product. This also
applies to CE Marking as defined by the R&TTE Directive.
• However, in many cases, the module may need to be retuned, due to the effects of the
product enclosure and assemblies within this enclosure, and the de-tuning affect that this
may have on the radio circuitry. In this case and if other radios exist, Class 2 Permissive
Change is required.
• In the event that the HID OEM modules Kit is modified in any way, the radio transmitter
operating at either 125 kHz, 13.56 MHz and Bluetooth, when the module is integrated into the
OEM's final product, Radio Certification is required for the final product.
• Obtain FCC Certification by submitting the final product to a Telecommunications Certified
Body (TCB) laboratory that performs the testing and issue the FCC Grant. Standard: Part 15,
Subpart C.
• Often the same TCB tests to Canada requirements and grants certification as a Certification
Body (CB). Standard: RSS-210, RSS-GEN and RSS-310, where applicable.
• The same laboratory may also be an EU Communications Assessment Body (CAB) that is
accredited to test to R&TTE Directive requirements for CE Marking. Applicable standards:
EN 300 330, EN 301 489-3, EN 50130-4, and IEC60950.
• A laboratory that is a CAB testing to R&TTE Directive requirements will also be testing to
Australia and New Zealand requirements because of a common test standard. Standard:
AS/NZS 4268.
• Asian country certifications are obtained on an individual country basis.
OEM Final Product US Dept. of Commerce Bureau of Industry and Security (BIS) approval is
required for USA based companies who export and re-export products using encryption.
Regulatory Compliance Assistance - HID Global provides technical assistance and laboratory
recommendations, as required.
4
Installation Guide
3120-906 B.6.