HID ProxPoint Plus Manuel d'installation - Page 2

Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} HID ProxPoint Plus. HID ProxPoint Plus 2 pages.

Imprimer la page

PARTS LIST (Included)

- ProxPoint Plus

Reader with snap-on

cover and 18" cable

- #4-24 x 1" self-tapping flathead screw

- Installation manual

PARTS LIST (Not

PARTS LIST (Not- - - - Included)

Included)

PARTS LIST (Not

Included)

- Wire splice

- DC Power supply 5.0 VDC or 12 VDC

Mounting Instructions

• Determine an appropriate mounting location. The

reader may be mounted to any surface, including

metal.

• Drill two (2) 5/64-inch (2mm) holes approximately 1

inch deep for mounting the reader.

• Drill a 5/8-inch (16mm) hole for the cable.

• Remove the snap-on cover from the reader and

secure the reader to the mounting surface.

• Route the cable from the reader and/or power

supply to the host. A linear type power supply is

recommended. Check all electrical codes for proper

cable installation.

• Test the operation of the reader. After completion of

the test, replace the snap-on cover.

_____________________________________________________________________________________________________

HID Corporation 9292 Jeronimo Road Irvine, CA 92618-1905 USA TEL (949) 598-1600 (800) 237-7769 FAX (949) 598-1690

Web page, E-mail - www.hidcorp.com - ProxPoint Installation Manual 6005B-910 Rev A

Connecting the Reader to the Host

Quantity

Connect the reader to the host according to the wiring

table below and the host installation guide.

Wiegand

+DC

Ground

---

Quantity

Data0

Data1

Shield Ground

Green LED

Red LED

Beeper

Hold

Testing and Operation

• When power is applied to the reader the LED will

flash green three (3) times while the beeper beeps

simultaneously. The LED will then turn red. This

indicates that the microcontroller is operating

properly.

• Present an ID card to the reader. The LED will

momentarily turn green while the beeper beeps

once, indicating that the card was read successfully.

Important Product Specifications

Power requirements (linear supply)

Operating Voltage Range

Absolute Maximum Voltage

Peak Current

Average Current 5V or 12V

Maximum cable distance

To host

FCC Compliance Statement:

FCC Compliance Statement: This device complies

with part 15 of the FCC rules. Operation is subject to

the following two conditions: (1) this device may not

cause harmful interference, and (2) this device must

interference that may cause undesired operation.

Clock & Data

+DC

Ground

Card Present

Data

Clock

Shield Ground

Green LED

Red LED

Beeper

Hold

5.0 – 16.0 VDC

18 VDC

80 Ma

20 Ma

500 ft (153 m)

any

interference

received,

Page 2 of 2

Wire Color

Red

Black

Violet

Green

White

Drain

Orange

Brown

Yellow

Blue

including