Dynalink RTA1046VW Spécifications - Page 2
Parcourez en ligne ou téléchargez le pdf Spécifications pour {nom_de_la_catégorie} Dynalink RTA1046VW. Dynalink RTA1046VW 3 pages. Adsl2+ wireless voip router
Également pour Dynalink RTA1046VW : Manuel de configuration (7 pages)
Imprimer la page
Technical Specifications
ADSL Compliance
ADSL
• ANSI T1.413 Issue 2
• ITU G.992.1 Annex A (G.dmt)
• ITU G.992.2 Annex A (G.lite)
• ITU G.994.1 (G.hs)
• Support dying gasp
• Maximum Rate: 8 Mbps downstream and
1 Mbps upstream
ADSL2
• ITU G.992.3 Annex A (G.dmt)
• ITU G.992.4 Annex A (G.lite)
• Maximum Rate: 12 Mbps downstream and
1 Mbps upstream
ADSL2+
• ITU G.992.5 Annex A (G.dmt)
• Maximum Rate: 24 Mbps downstream and
1.2 Mbps upstream
ATM
• PPPoA (RFC 2364) and PPPoA Bridged mode
• PPPoE (RFC 2516) and PPPoE Bridged mode
• IPoA (RFC 2225)
• Bridged mode over AAL5 (RFC2684/1483)
• ATM Forum UNI 3.1 / 4.0 compliant PVCs
• UBR and CBR with traffic shaping
• OAM F4/F5 loopback cells
Bridging
• IEEE 802.1d self-learning bridge
• Learning up to 4096 MAC addresses
• Transparent Bridging between 10/100 Mb
Ethernet and USB
• Supports IGMP Snooping
• Supports 802.1Q VLAN packet pass-through
Voice over IP Features
• Call Feature: basic outgoing and incoming
call, Call Waiting, Three Party Conference, Call
Transfer, Caller ID (only when supported by
service provider).
• Call Control: SIP (RFC3261)
www.dynalink.co.nz
www.dynalink.com.au
All-in-one Integrated Access Device
(RTA1046VW)
• Voice Transport: compliance to RTP (RFC1889)
• Voice Codec: G.711 (a-law and u-law),
G.726 and G.729
• Tone/Ring Signal: compliance to Australia & New
Zealand standards.
• Tone Detection: support DTMF
• Echo Cancellation: G.168 compliance
• Support FAX/Analog Modem function via
PSTN port
• Support RFC2833 RTP Payload for DTMF Digits,
Telephony Tones and Telephony Signals
• Two VoIP (FXS) ports for VoIP phone calls
supporting intelligent lifeline backup when there
is no Internet service.
• Manual selection of PSTN mode or VoIP mode for
making phone calls
• Automatic selection of PSTN when an emergency
number is dialled.
Routing
• NAT / PAT allows multiple users to share
Internet access
• UPnP IGD with NAT traversal capability
• Port Forwarding: users can setup multiple virtual
servers (e.g., Web, FTP, Mail servers) on the
local network.
• Static routing & dynamic routing RIPv1/v2
• DNS Relay, Dynamic DNS
• DHCP Client/Relay/Server
• IGMP Proxy
• Support IP/Bridge QoS for different traffic classes
• Support 802.1Q VLAN Tagging
Configuration and Management
• Embedded web configuration interface with
password protection
• Remote management control
• Telnet session for local or remote management
• System events logging
• DSL connection diagnostics
• Firmware upgrade via web browser
• User setting backup & restore
• SNMPv1/v2 agent with MIB-II, ADSL Line MIB