Celestron 22006 Manuel d'instruction - Page 2
Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} Celestron 22006. Celestron 22006 7 pages.
Imprimer la page
WHAT'S IN THE BOX
We recommend saving your telescope box so it can be used to store the telescope when it is not in use. Unpack the box carefully as
some parts are small. Use the parts list below to verify that all parts and accessories are present.
PARTS LIST
Bluetooth Remote
Smartphone Adapter
Erect Image
Diagonal
SOLAR WARNING
Never look directly at the Sun with the naked eye or with a telescope unless you have the proper solar filter. Permanent and irreversible eye damage may result.
Never use your telescope to project an image of the Sun onto any surface. Internal heat build-up can damage the telescope and any accessories attached to it.
Never use an eyepiece solar filter or a Herschel wedge. Internal heat build-up inside the telescope can cause these devices to crack or break, allowing unfiltered
sunlight to pass through to the eye.
Do not leave the telescope unsupervised, especially when children or adults unfamiliar with the correct operating procedures of your telescope are present.
ASSEMBLY
Set up your Travel Scope 60 indoors the first time and familiarize yourself with the correct assembly procedure before attempting it outdoors.
SETTING UP THE TRIPOD
1. The tripod comes preassembled. Stand the tripod upright and pull the tripod legs outward until each leg is
fully extended.
2. You can raise the tripod legs to the height you desire. At the lowest level, the height is about 16" (41 cm) and
extends to about 49" (125 cm).
3. To raise the height of the tripod, unlock the tripod leg lock clamps at the bottom of each tripod leg by opening
the clamp for each section and pulling outward. Once a clamp is unlocked, pull the tripod leg out as far as it will
go, and then close the leg lock to secure it. Continue doing this for each tripod leg and each section to raise the
height to the level you desire.
4. If you want to raise the tripod height up further, use the central column locking knob. Turn the locking knob
counterclockwise until loose. Then, pull up on the head of the tripod. Continue pulling to the height you desire
and then tighten the locking knob.
Pg. 2
Optical Tube
Finderscope
Focus Knob
Pan Handle
Objective Lens
(under lens shade)
Tripod Head Platform
Central Column Locking Knob
Tripod
OTHER INCLUDED ACCESSORIES:
1.25" Moon Filter
10 mm Eyepiece
20 mm Eyepiece
3x Barlow Lens
Travel Backpack