Dynalite DMC810GL Manuel d'installation - Page 7
Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} Dynalite DMC810GL. Dynalite DMC810GL 12 pages. Leading edge dimmer/hf ballast controller
Imprimer la page
preset programming using the program key
.........................................................................................................................
AUX Input - This is a dry contact interface that is active low. The dry contact is connected between the AUX
and GND terminals on the DyNet connector strip. The function of the AUX input is programmable. Ensure
that the cable length between the dry contact and terminal strip is no longer than 2 metres.
Service LED - The Service LED has 3 signalling modes, which are useful for troubleshooting:
Blinking slowly (1Hz) = Normal Operation
Blinking fast (4Hz) = Network Activity Detected
On = Fault
Service Switch - The Service Switch has three functions:
1 push = Transmit Network ID
3 pushes = All Channels 100%
Push & hold for 4 sec = Reboot
Top Set - This adjusts the maximum output that all other control sources can select, ie: if the Top Set is fully
clockwise, 100% selected by a control source will give 100% output. If it is fully anti-clockwise, 100%
selected by a control source will give 50% output. This control is useful for extending lamp life and can be
operated without any form of network control, effectively turning the device into a stand-alone power
conditioner and lamp protector.
Accessory Module Socket - Accepts plug in multi function accessory modules for optional features such as
additional dry contact inputs, 2
available accessory modules.
.........................................................................................................................
INCANDESCENT
Incandescent lamps are easily dimmed using all Dynalite controllers. The soft start and
voltage limit features will extend lamp life. Lamp life can be further extended using the
LAMPS
voltage limit adjustment.
TUNGSTEN
Tungsten halogen and other transformer loads are easily dimmed using all Dynalite
controllers. The soft start and surge limiting features will protect lamps against premature
HALOGEN
failure.
LAMPS
transformer is designed for dimming.
FLUORESCENT
26mm slimline tubes can be dimmed to as low as 1% using a dimmable electronic ballast.
No de-rating is necessary with electronic ballasts. Contact your Dynalite dealer for more
LAMPS (26mm,
information.
T8)
FLUORESCENT
16mm slimline tubes can be dimmed to as low as 1% using a dimmable electronic ballast.
No de-rating is necessary with electronic ballasts. Contact your Dynalite dealer for more
LAMPS (16mm,
information. Must be dimmed with electronic ballasts which accept 1-10V, DSI or DALI
T5)
broadcast.
COMPACT
Only some types of CFL lamps can be successfully dimmed. Best results are achieved with
dimmable HF ballasts
FLUORESCENTS
.........................................................................................................................
nd
DyNet port and Time clocks. Consult your distributor for details on the
Lamp life can be extended using the voltage limit adjustment. Ensure that
dimmable lamps chart
DMC810GL Instruction Manual Rev B.DOC
7