Gainsborough K323 Manuel rapide - Page 2

Parcourez en ligne ou téléchargez le pdf Manuel rapide pour {nom_de_la_catégorie} Gainsborough K323. Gainsborough K323 3 pages. Copper flower solar stake lights set 2

Imprimer la page

Copper Flower Solar Stake Lights Set 2

Please read and retain these instructions for future reference

Step 2:

Remove the screws from the battery cover

(Figure 2).

Step 3:

Carefully lift the cover to access the battery

compartment, being sure not to detach any

of the connected wires (Figure 2).

Step 4:

Replace the battery with an equivalent new

solar rechargeable battery (1x AAA NI-MH);

ensuring the correct polarity is observed

(Figure 2).

Step 5:

Reassemble the unit by reversing the above

procedure.

Charge under direct sunlight in the <ON>

position for 2 days.

Find an ideal Place for the Solar Light.

Place the solar light in an area where it will receive direct sunlight for at least 8 hours per day. The number of

hours the light will illuminate is directly proportional to the hours of sunlight it receives. If the light is placed

in a shaded area, it will not be able to fully charge and its illumination time will be limited. Do not place the

light near other outdoor lighting like porch or streetlights. These may fool the sensor and keep the light from

coming on, or cause it to turn off automatically

TROUBLE SHOOTING TIPS

If your solar light does not come on at dusk despite following all instructions please try the following steps:

1. Make sure that the solar light is not affected by any other light source.

2. Ensure the solar light does not stand in the shade all day.

3. Check to see if the batteries are installed correctly.

4. If there is a protective film on the solar panel remove it.

CARE INFORMATION

•

Clean any dirt and debris from the solar panel. The panel cannot recharge if the light is obstructed. Use

a soft cloth to clean the panel. Do not use abrasives or chemicals that might scratch or damage the UV

coating.

•

In a region where snow and ice are likely and the light assembly is covered with snow for an extended

period of time the batteries will require a recharge for at least 8 hours.

•

Make sure all connectors are still tight and no water getting in.

Instructions for Use

K323

Fig. 2

v001: 11/10/21