DB Drive EUPHORIA M1000 Manuel de l'utilisateur - Page 7
Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} DB Drive EUPHORIA M1000. DB Drive EUPHORIA M1000 9 pages.
Imprimer la page
ADJUSTMENTS AND SETTINGS
( T265, F465, F490, F4125 )
Built-in Crossover
T265 , F465, F490 and F4125
network that allows you to select the crossover mode (Highpass—Full Range) and desired
crossover point for channels 1 and 2. Channels 3 and 4 allow you to select between a
Highpass 12db slope, a 12db Stereo Lowpass / Bandpass slope and a mono 24db Lowpass /
Bandpass slope. For example if you wish to drive a pair of subwoofers on channels 3 and 4
out the high frequencies with a 24db slope. You will then need to adjust the Lowpass
control to the desired frequency setting (make sure to have the Highpass control set to
switch to LP/BP stereo. Once the LP/BP stereo switch setting is selected you will use both
any unwanted low frequencies with a 12db slope.
Channel 3 & 4 X-Over Controls
High
Low
Bass
Pass
Pass
Boost
Gain
20Hz 1KHz
50Hz 5KHz
0dB 12dB
Min Max
Mode
LP/BP Mono 24dB
HP 12dB
LP/BP
Stereo
12dB
INPUT
OUTPUT
INPUT
Channel 1 & 2 Over Controls
Ch 4
Ch 4
Ch 2
High Pass
Gain
Full
HP
X-OVER
Min Max
20Hz
5KHz
4 CHANNEL AMPLIFIER
F465
Ch 3
Ch 3
Ch 1
ADJUSTMENTS AND SETTINGS
( M350 , M500, M100 M2000 )
The M350 , M500, M1000 and M2000 are equipped with a variable 24db slope
feature a variable Bass Boost EQ is set at 45Hz. In some subwoofer enclosure installations it
may necessary to use the Phase Shift feature. The Phase Shift button sets the Subwoofer
subwoofer enclosure. M500, M1000 and M2000 are equipped with Multi-Linking technology.
When using a single Linkable amp set the Master / Slave switch to the Master position.
the slave setting the front panel controls become inoperative. All adjustments for both
FINE TUNE THE SYSTEM
Euphoria
Euphoria