GainSpan GS1011MEP-EVB Manuel de l'utilisateur - Page 4

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} GainSpan GS1011MEP-EVB. GainSpan GS1011MEP-EVB 12 pages. Serial to wi-fi evaluation kit

Imprimer la page

-F

ERIAL TO

Below are the steps required to run the serial to Wi-Fi application.

1. Once the software installation is completed, power the Wi-Fi Access Point (AP). The access point

have been pre-configured with the following parameters:

a. SSID = "GainSpanDemo

b. Channel = 6

c. DHCP = Enabled

d. Security = Open

e. IP Address = 192.168.3.1

Note: If user wants to use a different AP than the one provided with the kit, user can use any standard

Wi-Fi (802.11 b/g/n) AP, they should just ensure that the AP settings match the parameters above.

2. Plug the serial cable provided directly into a serial communications port of the PC if one is

available, or into a USB-to-serial converter. Since USB converters can enumerate to any one of a

number of COM ports, it is necessary to find the COM port of the serial port or USB converter being

used to communicate with the board. Open the Device Manager (Figure 1): Start → Settings →

Control Panel → System → Hardware → Device Manager. The USB Serial Port is listed under

as shown below

(COM & LPT),

Figure 1: System Properties pane with Device Manager Button

RELIMINARY

ETUP AND

TART

AGE

Serial to Wi-Fi Start Up Guide

NSTRUCTIONS

Ports

ONFIDENTIAL