GainSpan GS1011MxP-EVB Series Manuel de l'utilisateur - Page 5

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} GainSpan GS1011MxP-EVB Series. GainSpan GS1011MxP-EVB Series 12 pages. Serial to wi-fi evaluation kit

Imprimer la page

2. Connect the Serial Cable provided with the kit to either the 6-pin UART connector as shown be-

low or to the DB9 connector depending on the type of cable that is being used.

3. Launch the Tera-Term Application. Select serial port connection, and select the serial port identi-

fied in step 2. Set the port settings as shown below.

4. Install the batteries provided with the kit into the battery holder.

NOTE: Make sure the power switch (SW1) is in the OFF position. Make sure that the battery's

positive (+) terminal aligns with the battery holder's positive (+) terminal indicator before inser-

tion. Improper placement of the battery may damage the evaluation board.

5. Power on the Evaluation board by switching the power switch SW1 to the "ON" position. Tera-

Term will display "Serial to WiFi App" for an internal PA board (GS1011MIP-EVB) or "Serial

to WiFi App-Ext. PA" for an external PA board (GS1011MEP-EVB or GS1011MEE-DB).

6. By default the board will not have a network setup. To look at the network stat type "at+nstat=?

In the tera-term window. To look for available wireless networks and associate with one, below

are the steps

a. To scan for available Wi-Fi access points, type "at+ws" on the Tera-Term screen

RELIMINARY

Serial to Wi-Fi Start Up Guide

Black Wire

Indicates

Pin 1

SW1

Off

AGE

ONFIDENTIAL