Hideaway Beds Beta Bed Double Manuel d'instructions de montage - Page 16

Parcourez en ligne ou téléchargez le pdf Manuel d'instructions de montage pour {nom_de_la_catégorie} Hideaway Beds Beta Bed Double. Hideaway Beds Beta Bed Double 20 pages. Wallbed frame and cabinet system

Imprimer la page

Ends

4 1/2"

(114)

3/4" (19)

4 1/2"

(114)

3/4" (19)

3/4" x 4 1/2" x 62 1/8" (19 x 114.3 x 1578mm)

4 1/2"

(114)

STEP 6: Assemble Bed Face Panel Unit - Prepare and assemble Cleats

and Rails and attach to Bed Face Panel (cont.)

Now "tack" this assembly together by loosely placing screws in the pilot holes nearest

the corners. Be sure the unit is absolutely square. Now glue and screw the center

stiffener in place. Check assembly for square and alignment. Now glue and screw the

two other Stiffeners into position. All of the above assembly should be done with glue

and #8 x 1 1/4" wood screws.

Place the pre-assembled Cleats and Rails in their proper position on the Bed Face

Panel. Use Drawing #8 as your guide to the final placement of the Cleats and Rails.

Glue and screw the Cleats and Rails securely to the Bed Face Panel; be sure you

have the 1" (25mm) overhang of the panel on two sides and the foot and that the

head Rail is flush with the Head End of the Bed Panel.

Now that the Side and End Rails and Cleats are attached to the Bed Face, you have

some minor tasks to complete.

NOTE: Lift Mechanism mounting holes #1 and #2 are partially blocked by the Cleats

on both the left and right side. Using a 3/4" (19mm) spade bit, drill away enough of

the Cleat so the nuts and washers for the mounting bolts will have adequate clear-

ance.

Tape the tops and ends of the Side and End Rails for a more finished appearance

and to prevent possible snagging.

Attach the Velcro straps approximately 16" from the Foot end of the Cleats. Use the

3/16" x 3/4" (O.D.) washers and #8 x 3/4" wood screws. Fold the Velcro strap over to

screw through for extra strength. The Velcro hooks and loops should face each other.

10.

Press fit the Confirmat screw caps on all 12 Confirmat screws at the corners of the

Rails.

11.

Attach the Universal Panel Saver Guards at the Bed Panel Head Corners shown in

Drawing 11a.

3/4" (19)

3/4" x 4 1/2" x 41 1/8" (19 x 114.3 x 1045mm)

Single End

40 1/2" (1045)

3/4" x 4 1/2" x 56 1/8" (19 x 114.3 x 1426mm)

Double End

55 1/2" (1426)

King End

61 1/2" (1578)

3/4"(19)

4 1/2" (114)

3" (76)

2 1/4" (57)

3/4"(19)

Ø5/16" (8) Bore Hole

Ø9/32" (7)

Ø3/16" (5)

Confirmat Screw

Plywood End Rail

Ø9/32" (7) Through Hole

Drawing 12.

16.