Hideaway Beds Beta Bed King Manuel d'instructions de montage - Page 10

Parcourez en ligne ou téléchargez le pdf Manuel d'instructions de montage pour {nom_de_la_catégorie} Hideaway Beds Beta Bed King. Hideaway Beds Beta Bed King 20 pages. Wallbed frame and cabinet system

Imprimer la page

STEP 3: Install the Springs on the Lift Mechanisms

NOTE: The maximum number of springs that each Lift Mechanism can use is nine. Nine

springs are provided for each lift mechanism; a varying number will be needed depending

on bed size, mattress weight, and materials added to the panel face such as moldings or

accessories.

Start by hooking one end of the spring under the up turned edge of the backer plate.

Lay the spring down and hook it into the matching hole in the T-shaped tension arm.

You may pry up this arm with a wood handle or shim to make inserting the hook easier.

NOTE: All hook openings should face you.

Install an equal number of springs on each side of the center hole. Imbalance of one

spring is O.K. to the topside.

You should use the same number of springs and the same number of holes on both the

Lift Mechanisms. However, to achieve balance, you may use one more spring on either

the right or left Side Mechanism.

If it is necessary to remove the Face Panel, to add or subtract springs, reverse the pro-

cedures listed on pg.17 step 7 "Install the Bed Face Panel in Cabinet." Be sure to

engage the Left and Right Arm Locks as you remove the Bed Face.

Spring Hole #1

Upturned Edge

of Mounting Plate

Center line

Spring Hole #9

ALERT:

If the bed slams shut, you must remove sufficient springs to have a soft closure. If the bed

does not rest lightly on the floor when open, add the weight of linens and blankets to see if

this helps balance. If you determine that you need more or less lift (springs) you should

remove the Bed Face and make the necessary change. Your bed will function for many

years when properly balanced so take the time now to make any needed adjustments.

Select your bed from this chart:

Tension Arm T-Bracket

Drawing 4.

10.