Gainstrong Oolite V3.5 Manuel - Page 14

Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} Gainstrong Oolite V3.5. Gainstrong Oolite V3.5 14 pages. Mt7628dan core module

Imprimer la page

ATTENTION

This device is intended only for OEM integrators under the following conditions:

1) The antenna must be installed such that 20 cm is maintained between the antenna and

users

2) This device and its antenna(s) must not be co‐located with any other transmitters except

in accordance with FCC multi‐transmitter product procedures. Referring to the multi‐

transmitter policy, multiple‐transmitter(s) and module(s) can be operated simultaneously

without C2P.

3) For all products market in US, OEM has to limit the operation channels in CH1 to CH11

for 2.4G band by supplied firmware programming tool. OEM shall not supply any tool or info

to the end‐user regarding to Regulatory Domain change.

USERS MANUAL OF THE END PRODUCT:

In the users manual of the end product, the end user has to be informed to keep at

least 20cm separation with the antenna while this end product is installed and operated.

The end user has to be informed that the FCC radio‐frequency exposure guidelines for an

uncontrolled environment can be satisfied. The end user has to also be informed that any

changes or modifications not expressly approved by the manufacturer could void the user's

authority to operate this equipment.

If the size of the end product is smaller than 8x10cm, then additional FCC part 15.19

statement is required to be available in the users manual: This device complies with Part 15

of FCC rules. Operation is subject to the following two conditions:

(1) this device may not cause harmful interference and

(2) this device must accept any interference received, including interference that may

cause undesired operation.

LABEL OF THE END PRODUCT:

The final end product must be labeled in a visible area with the following " Contains FCC

ID: 2AB5EOOLITE". If the size of the end product is larger than 8x10cm, then the following

FCC part 15.19 statement has to also be available on the label: This device complies with

Part 15 of FCC rules. Operation is subject to the following two conditions:

(1) this device may not cause harmful interference and

(2) this device must accept any interference received, including interference that may cause

undesired operation.