ActiveProducts 1450 Manuel d'instruction - Page 5

Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} ActiveProducts 1450. ActiveProducts 1450 17 pages. Electric

SAFETY FEATURES AND ELECTRICAL POWER INFORMATION

The pressure washer is equipped with a stop
device that will sense when the trigger on the gun
is released. It will open the power circuit to the motor
and cause the pressure washer motor to stop. Motor
will resume again when trigger is pulled.
Warning
The pressure washer is also equipped with a
main power "ON/OFF" switch located on the
unit. It should always be moved to the "OFF"
position when the pressure washer is not
being used to prevent possible injury or
damage.
Ground Fault Circuit Interrupter:
This pressure washer is provided with a ground-fault
circuit-interrupter (GFCI) built into the plug of the
power supply cord. This device provides additional
protection from the risk of shock. Should replacement
of the plug or cord become necessary, use only
identical replacement parts that include GFCI
protection.
Extension Cords
If possible, do not use extension cords with this
product. However, if you must use one, observe all
the warnings and instructions listed below:
Warning
Extension cords are not recommended unless
they are plugged into a groundfault circuit-
interrupter found in circuit boxes or protected
receptacles.
Use a sufficient gauge:
Maximum cable length: 50' = 14 AWG
Use only extension cords that are intended for
outdoor use. These extension cords are identified
by a marking "Acceptable for use with outdoor
appliances; store indoors while not in use."
Use only extension cords having an electrical rating
not less than the rating of the product.
Do not use damaged extension cords. Examine
extension cord before using and replace if
damaged. Do not abuse extension cord and do not
yank on any cord to disconnect.
Keep cord away from heat and sharp edges.
Always disconnect the extension cord from the
receptacle before disconnecting the product from
the extension cord.
To reduce the risk of electrocution, keep all connec-
tions dry and off the ground. Do not touch plug with
wet hands.
3