Celestron 44106 Manuel d'instruction - Page 14

Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} Celestron 44106. Celestron 44106 20 pages.

1. Take the Styrofoam container out of the cardboard carton.

2. Remove the tape from the Styrofoam container holding the two sections together.

3. Carefully remove the microscope and other parts from the container and set them on a table, desk, or other flat

surface.

4. Remove the plastic bag covering the microscope.

5. Remove the protective paper from the stage (5).

6. Remove the four objective lenses (4) from their containers. Unscrew the container lids from the threaded portion

of the objective lenses.

7. Thread the end of the 4mm objective lens into one of the holes on the nosepiece (12) until finger tight. It may be

necessary to lower the stage (5) by turning the coarse focus knob (3).

8. Now turn the nosepiece to the next opening and thread each of the remaining objective lenses into the remaining

holes.

Using the Illuminator Mirror

Your microscope has a built-in plano-concave illumination mirror which allows you to illuminate the specimen from the

bottom by reflecting an external light source (indirect sunlight, room light, lamp, etc.) to the stage. The mirror has a flat

side (you can easily see your reflection on the flat surface) and a concave side. The concave side will concentrate more

light onto the specimen than the flat side. To illuminate a specimen:

1. If it is daylight, tilt the mirror (6) and reflect indirect sunlight through the bottom of the stage (5). Warning: Never

use the mirror to focus direct sunlight through the microscope as this can be very harmful and may damage your

eyes.

2. If viewing at night or indoors, away from sunlight, you can use a nearby desk lamp, table lamp, or other light source

to reflect light onto a specimen.

To control the amount of light reflecting onto the specimen:

1. Use the concave side of the mirror to focus more light on the slide. The concave side will concentrate more light onto

your specimen but will focus a smaller beam of light, making it more sensitive to adjust.

2. You can also control light adjustment with the condenser and diaphragm -- see the section under "Adjusting the

Lighting".

Rotating the Head

The head of your microscope can be rotated 360°. Therefore, you can view from any position by just moving the head to

the desired location.

Setting Up Your Microscope

You are now ready to use your microscope!

Microscope Operation