DBI SALA 1201380 Manuel d'instruction de l'utilisateur - Page 5

Parcourez en ligne ou téléchargez le pdf Manuel d'instruction de l'utilisateur pour {nom_de_la_catégorie} DBI SALA 1201380. DBI SALA 1201380 8 pages. Rebar lanyards for work positioning

Imprimer la page

Double Leg Rebar Lanyard

(Connect one leg to each hip D-ring)

single Leg Rebar Lanyards with snap Hook: Connect the snap hook to the front D-ring on your

cross-over style full body harness. If using this rebar lanyard with a waist belt, slide the waist belt

D-ring to your front and connect the snap hook.

b. ConneCTIng To THe anCHoRage:

Connect the snap hook or carabiner on

the rebar lanyard to the intersection of the

horizontal and vertical rebar as shown in

Figure 6.

C. ConneCTIng THe PeRsonaL FaLL

aRResT sysTeM: Connect the personal

fall arrest system to the dorsal back

D-ring on your full body harness. See

Figure 2. See personal fall arrest system

manufacturer's instructions for more

information.

4.0

traInIng

4.1

It is the responsibility of the user to assure they are familiar with these instructions, and are trained in the

correct care and use of this equipment. User must also be aware of the operating characteristics, application

limits, and the consequences of improper use of this equipment.

WarnIng: Training must be conducted without exposing the trainee to a fall hazard. Training should be

repeated on a periodic basis.

5.0

InsPectIon

5.1

FReQuenCy:

•

before each use inspect according to steps listed in section 5.2. Remove equipment from field service

if it has been subjected to damage or has been subjected to a fall arrest force.

•

annually: This equipment must be inspected according to steps listed in section 5.2 by a competent

person, other than the user, at least annually. Record the results of each inspection in the inspection and

maintenance log in section 9.0.

WarnIng: If this equipment has been subjected to fall arrest forces, remove from service and destroy.

IMPortant: Extreme working conditions (harsh environments, prolonged use, etc.) may require increasing the

frequency of inspections.

5.2

InsPeCTIon sTePs:

step 1. Inspect rebar lanyard hardware (snap hooks, carabiners, quick-links, etc.) for damage, distortion,

sharp edges, worn parts, or corrosion. The snap hooks or carabiners must work properly. Hook

gates must move freely and lock upon closing.

step 2. Inspect the lanyard material as applicable:

Figure 5 - Connecting To your body support

Single Leg Rebar Lanyard

with D-ring

Rebar Lanyard

Single Leg Rebar Lanyard

with Snap Hook

Figure 6 - Connecting To The anchorage

Snap Hook or Carabiner

Connect Snap Hook or Carabiner to the intersection of the

horizontal and vertical rebar

Vertical Rebar

Horizontal Rebar