Dynamic Engineering PMC2PCI Manuel de l'utilisateur - Page 4

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Dynamic Engineering PMC2PCI. Dynamic Engineering PMC2PCI 9 pages. Pmc to pci converter

Imprimer la page

Product Description

For development or production use the PMC2PCI card to install a PCI form

factor device into a PMC compatible slot. Use less expensive or off-the-

shelf components until your PMC card is ready or for temporary debugging

situations. For production mode situations the available riser card will

reduce the effective height of the installed PCI card. The PMC2PCI is

64/66 capable and compatible with 32/33 systems. Both VIO voltages

are supported.

Special features :

• Single width PMC card with blank bezel.

• 10Ω series resistors on the A/D bus

• Clamping diodes on the control interface signals

• Zero delay buffer on clock.

• 3.3 and 5V PCI slots are on the rear of the card PMC Host sets the

signal levels.

• LEDs on key voltages

• Onboard 10 A switching regulator for PMC 3.3V supply

• Shunt selectable regulated or slot provided 3.3V

• Slot selectable secondary VIO reference voltage.

• 32 or 64 bit operation – PMC Host must support 64 bit operation for

that width to work in the PCI slot

• 66 or 33 MHz operation. PMC Host clock speed supported up to 66

MHz.

• JTAG programming support for PCI slots

• Busmode set to respond to PMC.

The PMC2PCI is ready to use with the default settings. Just install the

PMC2PCI onto the PMC slot and the PCI card into the PMC2PCI.

The only shunt selection is for the 3.3V source. Install for the on-board

10A regulator and open for the PMC supplied 3.3V power. The 3.3V

LED should illuminate in either case.

The PCI sockets are keyed and labeled for 3.3 or 5V PCI cards. The PMC

slot only supports one PCI attachment. Only one PCI card should be

installed at a time to prevent conflicts. Select either the 3.3V or the 5V

slot. If your application requires one of each or two of the same type to be

used we can add a bridge to the design to allow expansion from one PMC

slot to at least 2 active PCI slots. Please contact Dynamic Engineering for

this option or any other custom modifications that your system may

require.

Page

Electronics Design • Manufacturing Services