Hidrotermal HT-VC625-6W Manuel de l'utilisateur - Page 3

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Hidrotermal HT-VC625-6W. Hidrotermal HT-VC625-6W 5 pages.

3. Filter's Start-Up

1.Make sure the correct amount of filter sand is in tank and that all connections have been correctly

made and are secured.

2.Push the down control valve handle and rotate to BACKWASH position. (To prevent damage to

the control valve seal, always push down the handle before turning.)

3.Start the pump according to the pump manual.Never tun pump dry ！ Running pump dry may

damage seals, causing leakage and flooding ！ (Make sure all the suction and return lines are

opened), allowing the filter tank to fill in with water. Once the water is flowing out it removes any

fine sand particles and impurities from the sand media.

4.Stop the pump and set valve to the RINSE position. Start the pump and operate for 1 minute until

water is clear. Stop the pump and set the valve to the FILTER position and then restart the pump.

The filter is now operating at the normal filtering mode, removing dirt particles from the pool water.

5) Adjust the pool suction and the return valves to achieve desired flow. Check the system and the

filter for water leaks and tighten the connections, bolts, nuts, as required.

6.Acknowledge the initial pressure gauge reading when the filter is clean. (It will vary from each

pool depending on the pump and general piping system.) As the filter removes dirt and impurities

from the pool water , the accumulation in the filter will cause the pressure to rise and flow to

diminish. When the pressure gauge reading is 1.5 BAR higher than the initial "clean" pressure you

noticed, then it is time to backwash the filter (see BACKWASH under filter and control valve

functions).

NOTE: During initial clean-up of the pool water it may be necessary to backwash

frequently due to the unusually heavy initial dirt load in the water.

4. Fiberglass Filter Structure

1) Filter Replacement Parts

Figure 2

Item

Product Description

1.5" Top Mount Valve

1.5" Union with Sight Glass, O-ring

Oil Pressure Gauge with O-ring(40Psi)

Connector for Pressure Gauge

1.5" Union set with O-ring

Plastic Hose with Nut

O-ring for Pump

Pump Assembly Screw

Fastener for Filter Base

Water Drain Set

Combo Base

Laterals (126mm)

Lateral Assembly with center Pipe

Filter Tank

O-ring for Filter Neck

M6*50 Screw With Nut

Clamp Lock

Pump