Hidrotermal ARS-12.5 Manuel d'installation et d'entretien - Page 11

Parcourez en ligne ou téléchargez le pdf Manuel d'installation et d'entretien pour {nom_de_la_catégorie} Hidrotermal ARS-12.5. Hidrotermal ARS-12.5 12 pages. Automatic residential softener

Imprimer la page

※If the raw water fails to meet the standards of local tap water, such as the sediment concentration or

residual chlorine content exceed the stand,etc., the pretreatment device should be installed before the

device.(Such as Y type filter, ultra filter, and so on.)

※ During the operation, please check the brine tank regularly to ensure there is brine in the tank. And

when adding brine, please make sure that salt level is higher than water level(see picture I). When the

salt level is lower 1/3 of water level(see picture II), please add in time. (Attention: Make sure the

dissolving salt time is more than 6 hours so as to make the brine saturate)

Salt adding instruction

※ Please strictly use the salt of more than 99% purity only. Any salt with additive or large particles is

forbidden to add.

※ Please use this product under the water temperature between 5-45 ℃ , water pressure 0.15-0.6MPa.

Failure to use this product under such conditions voids the warranty.

※Sodium used in the water softening process should be consideered as part of your overall dietary salt

intake. Contact doctor if you are on a low sodium diet.

※Without being used for a long time or the pressure of the inlet water is instable, please close the inlet

port and turn off the power. Before using again, please firstly conduct a regeneration cycle through

manual operation so as to ensure the quality of soften water.

※During the service of product, prevent water hammer happened. Do not make these operations, such

as quickly and fully opening valve, or quickly and fully closing valve or shut off water pump,etc.

※If the water demand is increasing(Compared to usual demand) or the hardness of raw water is rising,

please reduce the regeneration cycle and increase the regeneration times, ensuring the soften water

yield.

※When use the softener for the first time or the device is idle for long period, it is normal that the outlet

water is yellow. Please put into use after 2-3minutes' rinsing.

※Sometimes the brine in the brine tank will forms salt bridge. That is, there is a space under the brine

which prevents the salt from being dissolved and hinders the resin regeneration. It is suggested to check

regularly. If there is salt bridge, please mash it.

※During regeneration period, there is no softened water for using. But if it still need water for using, it is

not suggested to bypass big quantity of hard water, it may affect the regeneration efficiency.

Salt adding

port

Salt

Salt level higher than water

level(picture I)

Salt

Water

Salt

Salt level lower 1/3 of

water level (picture II )

Water

Salt