Dynamic Projection MH08 Manuel d'installation rapide - Page 3
Parcourez en ligne ou téléchargez le pdf Manuel d'installation rapide pour {nom_de_la_catégorie} Dynamic Projection MH08. Dynamic Projection MH08 10 pages. Mirror head
Imprimer la page
Mirror Head Quick Installation Guide
For the full manual please visit
Technical specifications
• High resolution 16bit Pan / Tilt mirror movement
• DMX-512 control over 14 DMX channels
• DMX-IN and DMX-OUT / Through port (5-pin male and female XLR connectors)
• At least 5 channels are required to control the unit
• Art-Net™ connection (RJ45) (Art-Net™ designed by and Copyright Artistic License Holdings Ltd.)
• HTTP Control protocol
• High resolution micro step motors with maintenance free direct drive
• Self calibrating mirror position for high accuracy
• Absolute reposition accuracy smaller than 0.03°
• Movement accuracy: Pan and Tilt from the same direction to the programmed point within approximately 0.01°
• RS232 remote control connection for projector (D-sub 9 male) - cable included
• Flash-able firmware (Mini USB OTG)
• Ambient Light LED with high power 3 Colour LEDs (18Watt total).
• LED-Display for easy configuration
• Coated mirror for optimum reflection ~98% refraction factor
• Optimized mirror optics for the specific projector
• Passive cooled system, fanless (excluding projector)
• Environmental tolerances: Ambient operating temperature range: 5° – 35°C, Humidity: 20% – 80% (non-condensing)
• Mounting plate optimized for specific projector mounting.
• High durability black powder-coating surface finishing.
• DPCC web interface for easy show creation
• Package includes: RS232 cable, AC-loop through cable, Quick installation guide.
Examples of mounting and positioning the Mirror Head
„mirror up"
"floorstand up"
https://www.dynamicprojection.com/mh-support/
„mirror down"
"floorstand down"
Copyright © 2014 - 2022 Dynamic Projection Institute GmbH. All rights reserved. http://www.dynamicprojection.com
Weights and dimensions shown are approximate. Specifications and appearance are subject to change without notice.
~40°
Extended Mode
The illustrations show the approximate usable angular range of the projection cone
depending on the operation modes. The shown ranges may differ depending on the
lens-shift and blocking parts of the projector or mounting constructions. The modes
can be set in the firmware of the Mirror Head using the „System" menu.
Default Mode („90 Degrees"), this is the „90° Tilt" mode available on all Mirror Head
models.
TILT Extended Mode („162 Degrees") This mode adds more projection range to the
Mirror Head. Warning: Do not use the Extended Mode if your model does not support
it – if unsure ask the support.
3
A
~80°
Extended Mode
~115°
Default Mode
~110°
Extended Mode
~180°
Default Mode
QIG - Version 2.8