ADEMCO TS300 Instructions d'installation et d'utilisation - Page 4
Parcourez en ligne ou téléchargez le pdf Instructions d'installation et d'utilisation pour {nom_de_la_catégorie} ADEMCO TS300. ADEMCO TS300 4 pages. Dual temperature sensor

TS300 SPECIFICATIONS
Temperature Range / Accuracy (Local Sensor)
Temperature Range / Accuracy (Remote Probe)
Minimum Span between Hi and Low Limits
Alarm Delay
Alarm Output Type
Alarm Output Resistance
Alarm Output Rating
Audible Alarm
Audible Alarm Silencing
Input Voltage
Input Current Case Dimensions
Case Dimensions
T280R REMOTE TEMPERATURE PROBE (purchased seperately)
The T280R is a Remote Temperature Probe for use with the TS300. The Remote Probe is a sealed temperature sensor
with 15 feet of two conductor, 24 AWG stranded cable. The cable should be connected to the two terminals labeled
REMOTE. (Polarity need not be considered.)
Caution: Excessive force applied to the probe may damage the device.
Chemical Properties
Max. Compression Force Applied to Probe
Max. Tensile Force Applied Between Probe and Cable
Max. Cable Length
*
The T280R may be extended from 15' up to 300' using shielded 24 AWG cable. Insure the shield is grounded for
noise immunity.
Alarm Device Manufacturing Company, a Division of Pittway Corporation, and its divisions, subsidiaries and affiliates ("Seller"), 165 Eileen Way, Syosset, New York 11791,
warrants this sensor to be in conformance with its own plans and specifications and to be free from defects in materials and workmanship under normal use and service for
72 months from the date stamp control on the product. Seller's obligation shall be limited to replacing, at its option, free of charge for materials or labor, a sensor which is proved
not in compliance with Seller's specifications or proves defective in materials or workmanship under normal use and service. Seller shall have no obligation under this Limited
Warranty or otherwise if the sensor is altered or improperly repaired or serviced by anyone other than Ademco factory service. In case of defect, return the sensor to ADI or
an authorized distributor for an immediate replacement.
THERE ARE NO WARRANTIES, EXPRESS OR IMPLIED, OF MERCHANTABILITY, OR FITNESS FOR A PARTICULAR PURPOSE OR OTHERWISE, WHICH EXTEND
BEYOND THE DESCRIPTION ON THE FACE HEREOF. IN NO CASE SHALL SELLER BE LIABLE TO ANYONE FOR ANY CONSEQUENTIAL OR INCIDENTAL DAMAGES
FOR BREACH OF THIS OR ANY OTHER WARRANTY, EXPRESS O
DAMAGE IS CAUSED BY THE SELLER'S OWN NEGLIGENCE OR FAULT.
Seller does not represent that the sensor it sells may not be compromised or circumvented; that the sensor will prevent any personal injury or property loss by burglary, robbery,
fire or otherwise; or that the sensor will in all cases provide adequate warning or protection. Buyer understands that a properly installed and maintained alarm may only reduce
the risk of a burglary, robbery, fire or other events occurring without providing an alarm, but it is not insurance or a guarantee that such will not occur or that there will be no
personal injury or property loss as a result. CONSEQUENTLY, SELLER SHALL HAVE NO LIABILITY FOR ANY PERSONAL INJURY, PROPERTY DAMAGE OR OTHER
LOSS BASED ON A CLAIM THE SENSOR FAILED TO GIVE WARNING. HOWEVER, IF SELLER IS HELD LIABLE, WHETHER DIRECTLY OR INDIRECTLY, FOR ANY
LOSS OR DAMAGE ARISING UNDER THIS LIMITED WARRANTY OR OTHERWISE, REGARDLESS OF CAUSE OR ORIGIN, SELLER'S MAXIMUM LIABILITY SHALL
NOT IN ANY CASE EXCEED THE PURCHASE PRICE OF THE SENSOR, WHICH SHALL BE THE COMPLETE AND EXCLUSIVE REMEDY AGAINST SELLER. This
warranty replaces any previous warranties and is the only warranty made by Seller on this sensor. No increase or alteration, written or verbal, of the obligations of this Limited
Warranty is authorized.
TS300 SPECIFICATIONS
T280R Remote Probe Specifications
ADEMCO SIX-YEAR LIMITED WARRANTY
°
°
°
F to 140
F (0
C to 60
32
°
°
°
-40
F to 140
F (-40
C to 60
°
4
F (2.2
0 - 255 minutes in 1 min increments
(2) Form A reed relays
25 ohms maximum
50 mA max. @ 30VDC
4 kHz, 75 dB @ 10cm
pulsed 750 mS on/off
0 - 255 minutes in 1 min increments
7 to 16VDC
25 mA (max.)
4" x 2.6" x 0.9" (10.2cm x 6.6cm x 2.3cm
Non-corrosive, Waterproof
10 lb. force
5 lb. force
300 feet*
°
°
°
C) ± 3
F (± 1.7
C)
°
°
°
C) ± 4
F (± 2.2
C)
°
C)
N8188-2 4/97