Celia & Perah M6 Manuel de l'utilisateur - Page 14

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Celia & Perah M6. Celia & Perah M6 16 pages. Wireless scalable hi-fi audio system

Imprimer la page

Care and Maintenance

Care and maintenance
Cleaning
•
Be careful not to spill any liquid into any opening.
•
Wipe the speaker cabinet with a soft, clean, and dry cloth.
•
Wipe the speaker's soft grille with an electrostatic dusting cloth.
•
Do not use any solvent, chemical product or detergent.
C&PWireless Connection Feature Update
subwoofer and the Zone 2 Speakers are for updating the devices only: do not plug any cable or
USB flash drive into it.
Customer service
If you run into any issue, please contact us.
Service
website:www.celia-perah.com.
Service
Service line:+88602-23461011
Service address:5F., No. 31, Sec. 6, Xinyi Rd., Xinyi Dist., Taipei City 110, Taiwan (R.O.C.)
Warranty information
Products are guaranteed for one year. Visit our official website within two weeks from the
purchase to extend the warranty for half a year.
26

Troubleshooting

If you are experiencing any of the following problems, please follow the suggested steps:
① Make sure that the Main Speakers, Zone 2 Speakers and the Subwoofer are connected to the
power supply.
② Make sure that the RCA cables between the Main Speakers' left and right channel and the
Zone 2 Speakers' left and right channel are connected.
③ Check the status indicator of the Zone 2 Speakers and the Subwoofer connection (see pages
6, 7).
④ Keep the system away from any possible source of interference (wireless routers, wireless
phones, microwave ovens etc.).
⑤ Verify that the system is within the recommended range of your wireless router or mobile
device.
If the above steps do not solve the problem, please refer to the common problems and
solutions listed in the table below;if you still can't solve your problem, please contact us.
Problem
•
Press thePowerbutton on the back of the Main Speaker to manually
power on the system.
•
Press any button on the remote control to check whether the LED
display on the front of the Main Speaker is working properly.
The system is not
•
Make sure that the battery insulation slip is removed and that the
responding when
battery does not need to be replaced.
operating the
•
Unplug the power from the Main Speaker and plug it back in after 30

remote control.

seconds.
•
Make sure that the Main Speaker's control panel is not connected to a
USB cable which, in turn, is not connected to the PC. Please connect the
PC or unplug the cable from the control panel.
•
Increase the volume.
•
Press theMutebutton to make sure that the system is not muted.
No sound is
•
Make sure that the correct source is selected.
reproduced
•
Switch between different audio sources.
•
Make sure that the connection with the audio source is correct.
•
Check the volume of the audio source.
No sound
•
Make sure that the volume of the Zone 2 Speakers/Subwoofer is not
reproduced by
turned off.
Zone 2 Speakers/
•
Make sure that the C&P wireless connection is set up correctly.(See
Subwoofer
page 13)
•
Use theLOWbutton in theEQarea of the remote control and the ▲ , ▼
buttonsin theVOLarea to adjust the bass.
Bass is too strong
•
Use theSUBbutton on the remote control and the ▲ , ▼ buttonsin
or too weak
theVOLarea to adjust the volume of the subwoofer.
•
Keep the subwoofer at least 30 cm from the wall.
Troubleshooting
Solution
27