Hifionics Gladiator GLX1800.1D Manuel de l'utilisateur - Page 6

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Hifionics Gladiator GLX1800.1D. Hifionics Gladiator GLX1800.1D 16 pages. High performance amplifiers

Imprimer la page

GLX60.4 / GLX100.4 4-CHANNEL AMPLIFIER APPLICATIONS

Front/Rear high pass, using a 1 channel amplifier for mono sub bass

The combination of a 1 and a 4 channel amplifier, utilizing their built in

crossovers, makes it a snap to put together a full system with front and rear

highs, with mono sub bass.

Interconnect cable checklist:

- Using good quality RCA cables, feed the front and rear outputs of a head unit to

the inputs of the 4 channel amplifier as shown.

- Also connect the LINE OUT of the 4 channel amplifier to the LINE INPUT of the

1 channel amplifier as shown.

Mono bass woofer wiring:

Connect the mono speaker positive terminal to the LEFT +, and its negative

terminal to RIGHT -.

Switch setting checklist:

4 channel highs amplifier:

- 1/2CH X-OVER: HI

- 3/4CH X-OVER: HI

Crossover frequency control checklist:

- 4 channel highs amplifier:

Channels 1/2:

- HI PASS: 100 Hz

LOW PASS: N/A

STEREO

INTERCONNECT

RCA CABLE

Channels 3/4:

- HI PASS: 100 Hz

- LOW PASS: N/A

1 channel bass amplifier:

- Subsonic filter: 10 Hz to 40 Hz

- LOW PASS: 80 Hz

Please note that these frequency points are suggestions only. Refer to the

loudspeaker manufacturer specifications and the section "Setting up systems

after installation for best performance"

Level control checklist:

- Refer to the section "Setting up systems after installation for best performance"

Minimum final loudspeaker impedances:

4 Channel Amplifier:

- 2 ohm per channel in stereo mode.

- 4 ohm mono bridged.

1 Channel Amplifier:

- 1-Ohm to 4-Ohms

MONO

SUBWOOFER

1-OHM MINIMUM

TO BATTERY +12v

VIA FUSE

REMOTE TURN-ON

CHASSIS GROUND