DBK Drymatic Boost Bar FGPH107 Manuel d'instruction - Page 7

Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} DBK Drymatic Boost Bar FGPH107. DBK Drymatic Boost Bar FGPH107 18 pages. Adaptable heat drying system

Imprimer la page

Set up Guide

The Drymatic Boost should be set up using the following procedure:

Place Drymatic Boost Bar either flat or vertical on the floor with an air mover directed at one of the grills. A Fan to Boost

connector can be used to maximise airflow through the unit.

Optional - Connect any Drymatic Wall and Floor Systems or any accessories you may wish to use.

Plug the machine in and power on the air mover followed by the Drymatic Boost Bar.

Reset the kWh and Hours Run meters, set your maximum temperature and press Play.

1. Position Drymatic Boost with an air mover

Place the Drymatic Boost Bar in the area/room you wish to dry either flat on the floor or vertical as shown in the pictures be-

low. Position an air mover so that the outlet lines up with the Boost Bar.

Note - The air mover outlet should be approximately the same size as the Drymatic Boost intake and should be positioned a

maximum of 50cm (19") away from the grill. Ideally the air mover outlet should be as close as possible to the Drymatic Boost

inlet. We recommend that the air mover be rated for at least 1100m³/Hr (650 cfm). Failure to meet these requirements could

cause the machine to limit its power output or potentially cut the elements completely until airflow is improved .

Drymatic Boost Bar will always require airflow to function. The machine has sensors to detect the presence and temperature

of the input air and will control the heater accordingly. If no airflow is detected or if it is removed a no airflow symbol will

appear on the display to indicate this. When an air mover is added the machine will analyse the airflow for approximately one

minute to confirm that it is stable before heating up.

2.1 Optional - Connect Drymatic Wall and Floor System

If you wish to target dry an area you may wish to use a Drymatic Wall and Floor System (sold separately).

To connect a Wall and Floor System you will need to first put the Velcro adaptor around the outlet of the Drymatic Boost

Bar with the hook side up. Position the Wall and Floor System with the side with the holes facing down (logo on top) and

open it where you wish to connect the Drymatic Boost Bar.

Place the system around the Drymatic Boost Bar outlet and close the Velcro ensuring that a good seal is maintained. Once

the air mover is turned on the system will inflate and airflow will begin leaving the made through the small holes in the

bottom of the system.

Many systems are available and they can all be connected and extended via Drymatic Wall and Floor System connectors -

please contact your local Drymatic representative for more information. Once the system is connected the machine

should be set to the appropriate setting for the material being dried, see step four for information on the modes.