Hifonics MT OLYMPUS CYCLOPS 3K Manuel du produit - Page 6

Parcourez en ligne ou téléchargez le pdf Manuel du produit pour {nom_de_la_catégorie} Hifonics MT OLYMPUS CYCLOPS 3K. Hifonics MT OLYMPUS CYCLOPS 3K 13 pages. Mt olympus

Imprimer la page
Hifonics MT OLYMPUS CYCLOPS 3K Manuel du produit
DuaL aMP INStaLLatION PrOCeDure
10
Connect the amp LINE INPUTS to the Radio/CD player full range or mono line outputs with good quality
»
RCA interconnect cables.
Plug in the HFR-G1 bass remote module into the amp remote input DIN connection on the Master amp.
»
This will allow the Master amp to control both Master and Slave with just one Bass Remote.
»
Connect an RCA jumper cable from the Master amp MASTER OUTPUT to the Slave amp SLAVE
INPUT.
NOte:
This will "link" the amps so that the Master amp crossover switches will control both the
Master and Slave amps. The Slave amp crossover switches will be bypassed.
1.
Route two power cables (4-gauge for Odin 2K / 0-gauge for Cyclops 3K) directly to the vehicle battery
with an in-line fuse to EACH amplifier.
2.
Connect two ground cables (4 or 0-gauge) directly to the chassis within 18" of EACH amplifier.
3.
Be sure to remove any paint or primer from the ground point.
4.
Use a nut, bolt and lock washer to secure the ground cable to the chassis ground
5.
Make sure the Master amp MASTER/SLAVE switch is in the MST position.
6.
Make sure the Slave amp MASTER/SLAVE switch is in the SLV position.
7.
Connect the subwoofer(s) in accordance to the diagrams on the next page.
8.
Connect a 12 gauge jumper from Master amp speaker - to Slave amp speaker - as shown on the next
page.
Linking two amps for single or dual subwoofer application
Amplifiers are stable to 2-OHMS when linked
MASTER
REMOTE
PROTECT
INPUT
OUTPUT
LEVEL
PHASE
BOOST
WIDTH
CENTER
SUBSONIC
LPF
MODE
OUT
L
L
MST
SLV
9V
0.2V
0
180
0
10dB
30 100Hz
15
35Hz
35
250Hz
POWER
R
R
BASS EQ
SLAVE IN
SEE OWNERS MANUAL
Designed and Engineered in the U.S.A.
FOR DIAGNOSTIC CODES
MODE
MST
SLV
INPUT
OUTPUT
LEVEL
L
L
9V
R
R
POWER INPUT
+12V
POWER INPUT
SPEAKER OUTPUT
+12V
GND
REM
MODE
MST
SLV
MASTER
REMOTE
PROTECT
PHASE
BOOST
WIDTH
CENTER
SUBSONIC
LPF
MODE
OUT
MST
SLV
POWER
0.2V
0
180
0
10dB
30 100Hz
15
35Hz
35
250Hz
BASS EQ
SLAVE IN
SEE OWNERS MANUAL
Designed and Engineered in the U.S.A.
FOR DIAGNOSTIC CODES
SPEAKER OUTPUT
GND
REM
11