909 254CMS Manuel d'instruction - Page 14

Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} 909 254CMS. 909 254CMS 19 pages. 1800w 255mm (10") single bevel laser guided compound mitre saw

Imprimer la page

Setting the fence

square with the table

1. Make sure that the

electrical plug is removed

from the power point.

2. Push the saw arm (1) down

to its lowest position and

engage the release knob

(2) to hold the saw arm in

the transport position.

3. Loosen the mitre table lock

(15) (Fig. a).

4. Rotate the mitre table

(12) until the pointer is

positioned at 0º.

5. Tighten the mitre table lock

(15).

6. Using the 6mm hex key

provided, loosen the

four screws securing the

fence (11) to the base

(Fig. b).

7. Place a square against

the fence (11) and

alongside the blade

(Fig. c).

8. Adjust the fence (11) until it

is square with the blade.

9. Tighten the screws securing

the fence (11).

10. Loosen the Phillips head

screw holding the pointer

of the mitre scale (13)

and adjust it so that it

accurately indicates the

zero position on the mitre

scale (Fig. d).

11. Retighten the screw securing the mitre scale pointer.

Changing a blade

DANGER!

Never try to use a blade larger than the stated

capacity of the saw. It might come into contact with the

blade guards. Never use a blade that is too thick to allow the

outer blade washer to engage with the flats on the spindle.

It will prevent the blade screw from properly securing the

blade on the spindle. Do not use the saw to cut metal or

masonry. Ensure that any spacers and spindle rings that

may be required suit the spindle and the blade fitted.

1. Make sure that the electrical plug is removed from the

power point.

2. Push down on the operating

handle (3) and pull the

release knob (2) to

disengage the saw arm (1).

The release knob (2) can be

turned so that it is held in the

retracted position (Fig. e).

3. Raise the saw arm (1) to

its highest position.

4. Using a Phillips head screwdriver loosen and remove the

screw that secures the guard retraction arm (6) to the

rotating blade guard (Fig f).

5. Using a Phillips head screwdriver loosen and remove the

screw that secures the blade bolt cover (19) (Fig. g).

6. Pull the rotating lower blade guard (5) down then swing

it up together with the blade bolt cover (19). When the