909 LS15CS Manuel d'instruction - Page 7
Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} 909 LS15CS. 909 LS15CS 16 pages. 15 amp dual laser circular saw with magnesium
•
Support large panels to minimize the risk of blade
pinching and kickback. Large panels tend to sag under
their own weight. Supports must be placed under the
panel on both sides near the line of cut and near the
edge of the panel.
•
Do not use dull or damaged blades. Unsharpened or
improperly set blades produce a narrow kerf causing
excessive friction, blade binding and kickback.
•
Blade depth and bevel adjusting locking levers must
be tight and secure before making a cut. If the blade
adjustment shifts while cutting, it may cause binding
and kickback.
•
Use extra caution when making a "Plunge Cut" into
existing walls or other blind areas. The protruding blade
may cut objects that can cause kickback.
•
Do not use blades made of high-alloy, high-speed
steel (HSS).
•
Do not use the circular saw near fumes or combustible
liquids.
•
Secure small pieces of wood firmly before working.
Never hold them in your hand.
•
Never slow the blade down with your hands or by
applying pressure to the side of the blade.
•
Never apply force! Advance the circular saw gently
and steadily.
Extension cords
•
Replace damaged cords immediately. Use of damaged
cords can shock, burn or electrocute.
•
If an extension cord is necessary, a cord with adequate
size conductors should be used to prevent excessive
voltage drop, loss of power or overheating. The table
shows the correct size to use, depending on cord length
and nameplate amperage rating of tool. If in doubt, use
the next heavier gauge. Always use U.L. and CSA listed
extension cords.
RECOMMENDED SIZES OF EXTENSION CORDS
Tool's
Volts
Total length of cord in feet. Cord size
Ampere
in A.W.G. (minimum)
rating
25ft
3–6
120V~
18
6–8
120V~
18
8–10
120V~
18
10–12
120V~
16
12–16
120V~
14
Accessories
The 909 LS15CS Circular Saw is supplied with the following
accessories as standard:
1. Blade (fitted)
2. Blade wrench
3. Rip fence
Unpacking
Due to modern mass production techniques, it is unlikely
that your 909 Power Tool is faulty or that a part is missing.
If you find anything wrong, do not operate the tool until the
parts have been replaced or the fault has been rectified.
Failure to do so could result in serious personal injury.
Assembly
The 909 circular saw is packed, fully assembled except for
the rip fence.
7
50ft
100ft
150ft
16
16
14
16
14
12
16
14
12
16
14
12
12
-
-