Galaxy 790.6071 Series Manuel d'utilisation et d'entretien - Page 14

Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation et d'entretien pour {nom_de_la_catégorie} Galaxy 790.6071 Series. Galaxy 790.6071 Series 16 pages.

Imprimer la page

Before You Call

Before you carl for service, review this list. It may save you time and expense. The list includes common occurrences that

are not the result of defective workmanship or materials in this appliance.

OCCURRENCE

Range is not level.

Cannot move appliance

easily. Appliance

must be accessible

for service.

POSSIBLE

CAUSE/SOLUTION

Poor installation.

Place oven rack in center of oven. Place a level on the oven rack.

Adjust leveling legs at base of range until the rack is level. When range is level,

cooktop may appear out of alignment if countertop

is not level.

Weak, unstable floor. Be sure floor is level and can adequately

support range.

Contact a carpenter to correct sagging or sloping floor.

Kitchen cabinet misalignment

may make range appear to be unlevel. Be sure

cabinets are square and have sufficient

room for range clearance.

Cabinets not square or are built in too tight. Contact a cabinet maker to correct the

problem.

Contact

builder or installer to make appliance

accessible.

Carpeting interferes with range. Provide sufficient space so range can be lifted over

carpet.

Gas line is hard-plumbed.

Have a flexible A.G.A./C.G.A.

approved metal appliance

connector

installed.

Surface

burners

do not light.

Surface control knob has not been completely

turned to LITE. Push in and turn the

Surface control knob to LITE until burner ignites and then turn control knob to

desired flame size.

Surface bumerflame

burns halfway around.

Surface

burner flame is orange.

Burner ports are clogged. With the burner off, use a small-gauge

wire or needle to

clean ports. See "Surface Burners" in the cleaning chart under Care & Cleaning

for

additional

cleaning

instructions.

Range power cord is disconnected

from outlet (electric ignition models). Be sure

cord is securely plugged into the outlet. Pilot ignition models - is pilot lit.

Electrical

power outage (electric ignition models). Burners can be lit manually.

See

Setting Surface Controls.

Burner ports are clogged. With the burner off, clean ports by using a small-gauge

wire or needle.

Moisture is present after cleaning. Lightly fan the flame and allow burner to operate

until flame is full. Dry the burners thoroughly following

instructions

in the Care &

Cleaning

section.

Dust particles in main line. Allow the burner to operate a few minutes until flame

turns blue.

Oven does not operate.

Entire appliance

does not operate.

In coastal areas, a slightly orange flame is unavoidable

due to salt air.

Be sure the oven controls are set correctly for the desired function. See Setting

Oven Controls

or Entire Appliance

Does Not Operate (see below).

Be sure regulator gas valve is "ON". See installation

instructions.

Make sure electrical cord/plug is plugged tightly into outlet (electric ignition models).

Service wiring not complete. Contact your authorized

Sears Service

Center for

assistance.

Electrical

power outage (electric ignition models). Check house lights to be sure.

Call your local electric company for service. Surface burners can be lit manually.

See Setting Surface

Controls.

Be sure gas supply is turned on.