909 PS26W Manuel d'instruction - Page 12
Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} 909 PS26W. 909 PS26W 20 pages. 26cc pole trimming saw
Imprimer la pageFilling the tank
WARNING.
Always shut off the engine before fuelling.
Never add fuel to a machine with a running or hot engine.
Move at least 10m away from the refuelling site before
starting engine. Do not smoke when refuelling or operating
the line trimmer.
Note. It is normal for smoke to be emitted from a new
engine during and after first use.
1. Place the pole saw on the ground or on a sturdy bench
and wipe any debris from around the fuel cap.
2. Unscrew the fuel tank cap and pour the mixture into the
tank with the aid of a funnel.
3. Be careful not to spill any
mixture. If this happens, wipe
the spill with a clean rag.
4. Start the engine at least 10m
away from the area where
the fuel tank has been filled
up in order to avoid any risk
of fire.
Always use extreme care
•
when handling fuel! Fuel is highly flammable.
•
Never attempt to fuel the pole saw if the fuel system
components are damaged or are leaking.
•
Never attempt the refuel the engine while it is running or
still warm, allow it to cool before fuelling.
•
Never smoke or light any fires near the pole saw or fuels.
Always transport and store fuels in an approved container.
•
Never place flammable material close to the
•
engine muffler.
Never operate the pole saw without a properly functioning
•
muffler and spark plug cover installed.
Never operate the pole saw unless it is properly
•
assembled and in good working condition.
Do not use petrol which contains ethanol or methanol as
•
it may damage the fuel lines and other engine parts.
Mix only enough fuel for your immediate needs.
•
Do not store pre-mixed fuel.
Starting the pole saw
Choke control
Start position
(choke closed).
Run position (choke open).
1. Press the ignition switch
(2) to the 'on' position
marked with a I.
2. Move the red choke lever
(23) upwards to the start
position (cold start).
Note. This is not required if the engine is already warm.
3. Push the primer bulb 6-10 times, until the primer bulb fills
with fuel/oil mixture.
4. Squeeze the safety lever
(5) and the throttle trigger
(4) and engage the throttle
lock button (14). The throttle
lock button should engage
with the trigger approx half
pressed. Release the throttle
trigger. With the throttle lock
button engaged, the throttle
trigger will be partially depressed ready for starting.
Note. For cold starting this is an important step.
12
3
1
2
4