909 PS26W Manuel d'instruction - Page 15
Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} 909 PS26W. 909 PS26W 20 pages. 26cc pole trimming saw
Imprimer la pageWorking with the pole saw
Do not work with an angle higher than 60°. The pole saw
will work under higher degrees, but there is the danger of
being injured by branches falling without warning.
Keep an eye at the ground while working to avoid tripping
over fallen branches.
Never use the pole saw without oil, use good quality
chainsaw oil.
The pole saw is equipped with a low-kickback chain.
Nevertheless, do not use the tip of the chain bar when
cutting. Always use the lower or upper straight section of
the bar to reduce the event of kickback. Always hold the unit
firmly in both hands.
Thin branches can be cut off with one single cut. To prevent
the branch from slivering and buckling the branch should be
cut off in several pieces.
When cutting off larger branches, you should first cut into
the branch from below. First cut into the branch from below
outside the place where you intend to cut off the branch.
The cut should go from one third to halfway through the
branch. This prevents the branch from buckling when you
cut into the branch from the top outside the first cut. Last cut
off the stump with one clean cut. You might want to seal the
cut with a suitable compound.
Chain sharpening and maintenance
WARNING.
Note: Always make sure the engine is turned off
before making any adjustments or maintenance procedures.
Chain sharpening
Sharpen the chain regularly to maintain optimum
performance of the saw. Signs of a dull chain are:
The sawdust becomes powder-like
•
Extra force is required to execute a cut
•
•
The cut does not track in a straight line
Increased vibration
•
•
Increased fuel consumption
WARNING.
Wear heavy gloves when handling the chain.
Hold the guide bar securely in a vice.
Sharpen each cutter using a chain file. Always use outward
strokes.
After sharpening, the cutters must all have the same width
and length.
After every 3 - 4 times use a repair centre to professionally
sharpen your saw chain. They have the special tools
necessary to ensure the correct cutting angles and depths
are even.
Pole saw maintenance
WARNING.
Note: Always make sure the engine is turned off
before making any adjustments or maintenance procedures.
•
Always keep the air holes clean on the pole saw body.
They tend to become clogged with sawdust during
use and this affects the efficiency of cooling, causing
overheating of the motor the other fundamental parts of
the pole saw.
Do not operate the pole saw with the air intake on the
•
ground as this will draw foreign particles into the motor
area and damage the windings of the motor.
Regularly check to see if any dust or foreign matter has
•
entered the grills near the motor and around the on/off
switch. Use a soft brush to remove any accumulated
15