Galaxy DX 949 Manuel du propriétaire - Page 6

Parcourez en ligne ou téléchargez le pdf Manuel du propriétaire pour {nom_de_la_catégorie} Galaxy DX 949. Galaxy DX 949 12 pages. Solid state citizens band am/ssb mobile transceiver

Imprimer la page

13. PA/GNF/CB SWITCH : In the "PA" position, your voice will come out

of the speaker that you need to plug in to the "PA. SP." jack on the back

of the radio. The radio does not operate when you are in the "PA" mode.

The "CB" mode is normal operation of the radio. In the "GNF" mode,

you are in CB operation but the Galaxy Noise Filter (GNF) is engaged.

This is a special noise filter that de-emphasizes audio high frequency

response in order to increase the signal-to-noise ratio of weak signals.

While you will notice a dramatic reduction in the "rushing" sound when

this filter is activated, it does not have much effect on the signal-to-noise

ratio of strong signals.

14. MODE SWITCH : This control allows you to select one of the

following operating modes: USB/AM/LSB.

15. TONE SWITCH HI/MED/LO : This switch changes the tone quality.

In LO position, bass is increased and in HI position, treble is increased.

16. CHANNEL DISPLAY : The channel display indicates the current

selected channel.

17. SWR ALERT LED : This LED lights red when your SWR is higher

than about 3:1. This is not an exact indicator of 3:1 SWR, but it is an

indication that you should check your SWR reading.

18. R.B. LED : This lights green when the Roger Beep is on.

19. RX/TX LED : This LED is green during receive and red during

transmit.

- 9 -

REAR PANEL CONNECTOR

This device complies with part 15 of the FCC Rules.

Operation is subject to the condition that this device

does not cause harmful interference.

MODEL NO. : DX−949

FCC ID : M38 − DX − 949

AM / SSB 40 CH

CB TRANSCEIVER

MADE IN MALAYSIA

70900001

DATE OF MFG.:

SERIAL NO. :

1. ANTENNA : This antenna jack accepts 50 ohms coaxial cable with a

PL-259 type plug.

2. POWER : This accepts 13.8V DC power cable with built-in fuse. The

power cord provided with the radio has a black and red wire. The black

goes to negative and red goes to positive.

3. F.C. : This connector is for the optional Galaxy FC 347 six digit

frequency counter. All connections are made through this connector. No

soldering is required.

4. PA. SP. : This jack is for PA operation. Before operating, you must first

connect a PA speaker (8 ohms, 4W) to this jack.

5. EXT. SP : This jack accepts 4 to 8 ohms, 5 watts external speaker.

When the external speaker is connected to this jack, the built-in speaker

will be disabled.

- 10 -