909 LT18HT Manuel d'instruction - Page 11
Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} 909 LT18HT. 909 LT18HT 16 pages. 18v cordless hedge trimmer
Imprimer la pagetrimmer or recharge the existing battery, and then proceed
with the application.
Note:
Attempting to restart the tool in this condition without
either recharging the battery or installing a battery with
charge will lead to it restarting and then stopping again after
only a few seconds of operation.
These safety devices have been fitted for the safety,
reliability and life of the tool.
Fitting and removing the battery pack
To remove the battery pack from the tool or charger base
adaptor, firmly press the
battery release button at
the back of the battery pack
and slide the battery pack
backward, and then pull or
lift the battery out of the tool
handle or base adaptor.
To install the battery pack
into the tool or base adaptor,
align the keys of the battery
pack with the keyway slots in
the tool or base adaptor and
push the battery into the housing. To connect the battery,
slide the battery pack fully forward.
Battery charging
IMPORTANT.
Before plugging in the power supply from the
plug pack charger (7) to the charger base (8) always ensure
that the plug is switched off at the mains.
IMPORTANT.
The battery will be fully charged after approx.
3–5 hours: remove it from the charger after this time.
Do not leave a battery charging for longer than 24 hours.
1. Connect the power output lead from the plug pack
charger (7) to the back of the charger base (8).
2. Connect the plug pack charger (7) to a mains power
outlet (240Vac) and turn on. The indicator light on the
charger base should glow green, indicating power is
available at the charger base adaptor.
3. Align the battery pack (4) with the entry of the charger
base (8). Fully insert the battery.
4. The indicator light should now change from green to red,
indicating the battery is being charged.
5. When the battery is charged, the red light will change
back to a green light.
6. Remove the battery from the charger base and turn off
the plug pack charger. The green light should go off.
To obtain the best life for the battery
Never allow the tool to completely drain the battery and
come to a complete stand still before recharging. The
battery should be placed on charge whenever the battery
is noticeably running down or the tool no longer performs a
task it previously performed. For storage, charge between
50 and 75%. Avoid allowing loose items like screws or nails
etc. to be stored with battery packs as these or similar items
can short battery packs and cause a fire or explosion.
Always unplug the charger when not in use and store in
a dry secure place.
Avoid charging or storing your battery in temperatures
below 0ºC and above 40ºC.
11