909 BL18L Manuel d'instruction - Page 9

Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} 909 BL18L. 909 BL18L 13 pages. 18v sweeper/blower

Imprimer la page

When to charge the battery

New batteries are shipped in a low charged condition and

should be fully charged before Use.

Using the 3 – 5 hour charger the battery will be fully

charged in this period of time, or 1 hour using the fast

1 hour charger after the battery pack has been used and

charged a few times.

Unpacking

Due to modern mass production techniques, it is unlikely

that your 909 Power Tool is faulty or that a part is missing.

If you find anything wrong, do not operate the tool until the

parts have been replaced or the fault has been rectified.

Failure to do so could result in serious personal injury.

Important information – Product care

This blower uses Lithium Ion Battery Cells. Care

MUST be taken to ensure both the safety and life of the

pack is maintained. Ensure you have read all of the safety

notes in the previous pages before using the blower.

Safety devices and circuitry for this tool are located in

the battery pack of this tool. The battery pack is a vital

component, not just for the power source, but also for

the full safety control for both the charging and also the

tool operation. Treat the battery pack with care and within

the guidelines of this manual. If the pack does become

immersed in water or any fluids, or is subject to a severe

drop etc, or it does not operate within the guidelines of

this manual, immediately STOP using the battery pack

and have it checked.

As mentioned above the battery pack is an integral

component of this tool and it is fitted with thermal safety

devices. Running the blower at close to maximum load, or

continual resetting of the overload will cause the battery

pack to over heat. When a preset cell temperature is

detected, the battery pack will automatically STOP

operating and will not restart until the battery pack has

cooled to a safe level.

In this condition, DO NOT force cool the pack by placing in

a freezer or similar device. Refer to the "Overload" section

in this manual.

Another feature of the blower/battery pack is the low

voltage cut out feature. This feature operates when the

voltage drops below a pre set value. When this occurs the

tool will automatically stop operating. To correct the situation

you need to either insert another charged battery into the

blower or recharge the existing battery, and then proceed

with the blower application.

Note:

Attempting to restart the tool in this condition without

either recharging the battery or installing a battery with

charge will lead to the blower restarting and then stopping

again after only a few seconds of operation.

These safety devices have been fitted for the safety,

reliability and life of the tool.

Wear goggles

Wear ear muffs

Wear a breathing mask