Dynaphos CraftLine GS-300 Manuel d'instruction - Page 7

Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} Dynaphos CraftLine GS-300. Dynaphos CraftLine GS-300 8 pages. Studio flash

- mount the sender in the camera HotShoe connector with the control
panel towards to you and tighten the nut
- choose a working channel via the selector
from the power switch
- place the receiver in the USB sync port
and set on the same channel as the sender (check the further picture).
From the selector
9.
choose a working group. For work with more than
one flash, you'll have to place a corresponding number of additional
(product № 010289)
receivers FTR-16
the same channel as the sender. Preferably, the receiver of each flash
has to be set on a different group in order each flash to be control
separately.
- choose a working group (a flash) from the selector of the sender; to
change the power output of the flash use the "-/+" button 5; through
the "Lamp" button
10.
through the "Buzz" button
through the "Test" button
- Please notice, that the "Set" button
series.
- when pressing a button the indicator
pen place a new batteries and try again.
- after finnishing work turn off the receiver from the power switch
- keep the antenna
7.
6.
2.
10.
for each flash and set them on
you can turn on or off the modeling light;
3.
you can turn on or off the sound signal;
12.
you trigger the flash or make a test flash.
3.
is working only with WITSTRO
11.
must flash, if this don't hap-
save from mechanical damage
6
9.
and turn on the sender
(check page 2)
of the flash
1
2
3
4
5
6
2.
Guide
7
8
9
10
11
12
9