DynaQuip DRAINMASTER Mode d'emploi et manuel des pièces détachées - Page 2

Parcourez en ligne ou téléchargez le pdf Mode d'emploi et manuel des pièces détachées pour {nom_de_la_catégorie} DynaQuip DRAINMASTER. DynaQuip DRAINMASTER 9 pages.

Imprimer la page

Please read and save these instructions. Read carefully before attempting to assemble,

install, operate or maintain the product described, protect yourself and others by observ-

ing all safety information. Failure to comply with instructions could result in personal injury

and/or property damage! Retain instructions for further reference.

DynaQuip Automatic Drain Valves

DynaQuip automatic drain valves are motorized ball valves, used to automatically drain water,

oil and small debris from filters, tanks, drain legs, after-coolers and receivers.

SPECIFICATIONS

Adjustable cycle time

Max. working pressure

Ambient temperature

Enclosure

Voltage

Current

Valve construction

Seals

Discharge volume

Power adaptor

Full-Port ball valve

Discharge time

General Safety Information

Do not apply electrical power to the unit unless the unit is fully assembled and mounted. Failure

to do so could result in personal injury and/or damage to the unit. Disconnect power source and

depressurize the system before working on the unit. Failure to do so could result in personal

injury. The downstream or discharge side of the ball valve must be directed to a safe area for

collecting water, oil and debris. The compressed air system is pressurized during operation.

Appropriate precautions are recommended.

CAUTION:

It is recommended that eye protection be worn while servicing the system.

Failure to do so could result in personal injury.

WARNING:

The motorized drive unit case is not capable of supporting any loads. Do not

attempt to use the unit as a step. This will cause damage to the unit and could cause

personal injury. Do not use in hazardous locations.

CAUTION:

Do not use the case as leverage when mounting this unit or tightening fittings.

Use the wrenching flats on the valve body.

Installation

Figures 2 and 3 show typical installations of the drain valve. It is recommended that the

motorized drive be removed from the valve before piping the valve into your system. Then

reinstall the motorized drive unit to the valve. This can be done using the four screws holding

the valve to the case.

1. Install the automatic drain valve to the compressed air system at a point where moisture

would tend to collect.

2. Pipe the opposite end of the valve to your discharge area.

To order or for additional information, visit dynaquip.com or call 800-545-3636.

Operating Instructions and Parts Manual

1 min – 14 days

200 PSIG

35°F to 165°F

NEMA 4

12VDC

0.83 Amps

Lead Free brass NSF/ANSI 372

Reinforced Teflon

½"= 3.1, ¾" = 6.0, 1" = 7.7, 1¼" = 12.8 (gal. per cycle @ 80 PSI)

120V AC 20'

½" NPT including ¼" NPT reducer bushings, ¾", 1", 1¼" NPT

7 seconds non-adjustable

5.0"

5.33" (½)

5.88" (¾)

6.20" (1)

6.80" (1¼)

Figure 1

3.75"