Frigidaire 000 BTU Air Conditioner FAS226 Manuel d'instructions d'installation - Page 4
Parcourez en ligne ou téléchargez le pdf Manuel d'instructions d'installation pour {nom_de_la_catégorie} Frigidaire 000 BTU Air Conditioner FAS226. Frigidaire 000 BTU Air Conditioner FAS226 9 pages. For heavy duty (fas models) and median (fam models) air conditioners
Également pour Frigidaire 000 BTU Air Conditioner FAS226 : Schéma de câblage (1 pages)
Imprimer la page
3. Insert top and bottom legs of window filler panel frame
into channel in the to angle and bottom rail. Do both
sides.
4. Insert washer head locking screws (2) into holes in
top leg of filler panel frame (see Step 6). Do not totally
tighten. Allow leg to slide freely. Screws will be
tightened after Section 6.
Place Cabinet in
4
Window
1. Open window and mark
center of window stool.
2. Place cabinet in window with bottom stool angle firmly
scated over window stool as shown. Bring window
down temporarily behind top angle to hold cabinet in
place.
STOOL
3. Shift cabinet left or right as needed to line up center of
cabinet on center line marked on stool.
4. Fasten cabinet to window stool with 2 screws into
holes.(You may wish to pre-drill pilot holes.)
5. Add bottom rail seal over screws to window stool.
STOOL
ANGLE
Bottom
Rail Seal
3/4" long HEX-
HEAD SCREW
Install Support
5
Bracket
1. Hold each support bracket flush against outside of sill,
and tight to bottom of cabinet as shown below. Mark
brackets at top level of sill, and remove.
MARK
LEFT
LOCKNUT
SILL ANGLE
BRACKET
FLAT HEAD BOLT
2. Asscmble sill angle bracket to support brackets at the
marked position, as shown. Hand tighten, but allow
for any changes later.
3. Install support brackets (with sill angle brackets
attached) to correct hole in bottom of cabinet as shown.
4. Tighten all 6 bolts securely.
4
1/2" LONG SCREWS
AND LOCKNUTS
RIGHT
2 EACH REQ'D FOR EACH
SUPPORT BRACKET
1/2" long screws
and locknuts