909 52299 Manuel de l'utilisateur - Page 16

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} 909 52299. 909 52299 20 pages. 3500w inverter generator with pure sine wave

Imprimer la page

Maintenance

Spark Plug

To ensure the engine is operating correctly, the spark plug must be properly

gapped and free of carbon deposits. Always check the spark plug cable is

firmly fitted to the top of the spark plug.

WARNING: Ensure the engine is switched off while undertaking

this task.

1. Pull the spark plug lead (22) off the spark plug (23) and then remove spark

plug (23) from the generator using the supplied 21mm Spark Plug Tube

Spanner (31) by rotating in a clockwise direction (Fig Y).

2. Remove carbon deposits using a wire brush.

3. Check for discoloration on the top of the spark plug (23).

The standard colour should be a tan colour.

4. Check the spark plug gap. The acceptable gap should be between

0.6 – 0.8mm (Fig. Z).

5. The recommended spark plugs are as follows:

BPR6ES (NGK) RN11YC (Champion) WR6DC (Bosch)

CAUTION: Check that no foreign material, debris, or dust enters the

crankcase.

Replacement spark plugs are available from purchase from lawn mower or

small engine repair shops.

e-mail: [email protected]

MODEL: №. INF3800A • 52299

3500W Digital Inverter with Pure Sine Wave

AFTER SALES SUPPORT

1800 909 909

(toll free)

3500W Digital Inverter with Pure Sine Wave

Air Filter

It is very important to maintain an air filter (21) in proper condition. Damage to

the generator may arise if the filter has:

• Improperly been serviced.

• Dirt and other foreign elements adhering to the filter due to improper

installation and engine wear.

It is recommended the air filter (21) is cleaned every 50 hours (every 10 hours

under dusty conditions).

ALWAYS keep the filter clean at all times.

WARNING: Ensure the engine is switched off while undertaking this task.

1. Remove the air filter cover (20) on the side of the generator using the

supplied 10mm tube spanner (30) by removing (unscrewing) the two

screws on the face of the cover, in an anti-clockwise direction (Fig AA).

2. Remove the air filter (21) (Fig AB).

3. Wash the air filter (21) in hot soapy water and allow to dry.

4. Lubricate the air filter (21) using engine oil (SAE 10W-30).

5. Thoroughly squeeze the air filter (21) removing any excess oil.

6. Replace the air filter (21).

7. Secure the air filter cover (20) back on to the side panel of the air filter

housing using the supplied 10mm Tube Spanner (30) by screwing back in

the two screws in a clockwise direction until secure.

IMPORTANT. Never run the engine without the air filter element in place.

CAUTION: Never use fuel or low burning paint solvents to clean the air filter

(21). A fire or explosion could result.

CAUTION: Ensure the air

AA.

filter (21) is dry before re

fitting.

Replacement air filters

are available from www.

extrabattery.com.au or by

calling Customer Service

on 1800 909 909.