Autonics SCM-WF48 Manuel - Page 2
Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} Autonics SCM-WF48. Autonics SCM-WF48 3 pages. Communication converter
Également pour Autonics SCM-WF48 : Manuel rapide (11 pages), Manuel (13 pages), Manuel (11 pages)
Imprimer la page
• This unit may be used in the following environments.
- Indoors (in the environment condition rated in 'Specifications')
- Altitude max. 2,000m
- Pollution degree 2
- Installation category I
Cautions for Installation
• When wiring the RS485 connector, use AWG 24 cable.
• Tighten the connector screw with a tightening torque of 0.22 to 0.4 N m with the
screwdriver for M2 screw.
• Do not apply excessive pressure to the WiFi antenna. It may cause product damage.
Part Descriptions
01
03
04
01. WiFi antenna
02. Fixing screw hole
03. Rail Lock
04. Communication method switch (USB ↔ RS485)
05. Terminating resistance switch (RT ↔ OFF)
06. Indicator for modes
07. RS485 connector
08. USB connector
RS485 Connector
A
B
V
G
Installation
■ DIN rail mounting and removal
• Mounting
1. Hang up the backside holder on a DIN rail.
2. Press the unit toward ① direction until it snaps.
• Removing
1. Pull rail locks of the backside of the unit to ② direction.
2. Pull the unit to ③ direction.
②
①
Rail Lock
■ Mounting to panel
• This unit is able to mount on a panel with two fixing screws at center of both sides.
• Use M3 screws with a tightening torque of 0.4 N m.
■ USB driver installation
• Visit our website to download the driver.
• If the computer is connected to the Internet, your PC automatically searches for the
driver and install it.
• Check the status of the driver installed on your computer via Device Manager.
02
05
06
07
08
Pin
Function
A
RS485 (+)
B
RS485 (‒)
V
+V
G
Ground
③
Fixing screw hole
DIN rail
DAQMaster
• DAQMaster is the comprehensive device management program for Autonics' products,
providing parameter setting, monitoring and data management.
• Visit our website to download the DAQMaster installer and user manual.
Item
Minimum requirements
System
IBM PC compatible computer with Intel Pentium III or above
Operating system Microsoft Windows 98/NT/XP/Vista/7/8/10
Memory
256MB or more
Hard disk
More than 1GB of free hard disk space
VGA
1024×768 higher resolution display
Others
RS232 serial port (9-pin), USB port
How to use DAQMaster
01. Select USB via Communication method switch.
02. Connect your PC and SCM-WF48 with the enclosed USB.
03. Proceed device connection and communication mode via DAQMaster.
For detailed setting method, see the "DAQMaster User Manual."
04. Select RS485 via Communication method switch to connect with other
units.
Select RT via Terminating resistance switch to use terminating resistance.
Indicator for Modes
Mode
Indicator State
Green ON Power ON / AP ready
AP mode
Red ON
Station or device connection is complete
OFF
No power
Green ON Power ON
Station mode
Red ON
AP connection is complete
OFF
No power
Dimensions
• Unit: mm, For the detailed dimensions for the product, follow the Autonics web site.
108.5
76.3
2-Ø3.5
41.5
35mm DIN rail
• Panel cut-out
2-M3 TAP