Galaxy Medical Alert Systems Mobile System with GPS & Fall Detection Manuel de l'utilisateur

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Galaxy Medical Alert Systems Mobile System with GPS & Fall Detection. Galaxy Medical Alert Systems Mobile System with GPS & Fall Detection 4 pages.

Imprimer la page
Mobile System with GPS & Fall Detection
User Guide
Getting to Know Your Mobile System with GPS & Fall Detection:
Charging Your Device:
Whenever you put the plugged-in charging cable near the charging port on the back of the device, it should latch
into place and the device will automatically power on.
Note: Fully charge your Mobile System with GPS & Fall Detection before first use.
Please contact us with any questions.
Plug in the charging cradle and place the Mobile System with GPS & Fall Detection into the cradle as shown. Typically, a complete
charge will take approximately 2-3 hours time. The light flashes red every 5 seconds while charging and is solid red when the Mobile
System with GPS & Fall Detection is fully charged. Only charge as needed. Wear your device as often as possible to be protected.
#1
#4
how to call for help
H O W TO C A L L F O R H E L P
#2
#3
1)
Speaker
2)
Call Button
3)
Blue Call Light / Red Battery Light
4)
Microphones
How To Place A Call For Help
1.
Press and hold the call button and count 1, 2, 3, or until the light turns
blue, then release the button.
2.
After a short delay, you will hear a voice message and then tones or
ringing.
3.
The specialist will answer the call.
4.
The specialist can send emergency personnel or loved ones to help you.
If your Mobile System with GPS & Fall Detection does not connect properly,
please call the Galaxy Medical Alert Response Center at 1-855-905-7414 for
R E P L A C E L A N YA R D
technical assistance immediately.
W I T H B E LT C L I P
1. Remove the lanyard by twisting and
pulling silver clip.
Replace Lanyard With Belt Clip
2. Pull the lanyard and clip away from the
1.
Remove the lanyard by twisting and pulling silver clip.
Belle ® device.
2.
Pull the lanyard and clip away from the device.
3. Press the belt clip onto the back of
3.
Press the belt clip onto the back of the Mobile System with GPS & Fall
Belle as shown until it clicks.
Detection as shown until it clicks.
2
1
C L E A N I N G B E L L E W E E K LY
We recommend that you
LED
Announcement
Solid Red
Your device is now
fully charged.
Blinking Red
Your device battery is
low. For your protection,
please place your device
on the charger now.
Solid Blue Call Light
During an SOS call, the light
will be solid blue.
3
Galaxy Medical Alert Systems Ltd.
Battery life will vary based on settings selected.
What this means
Device is connected to the
charger. When fully charged,
the light will be solid red.
R E P L A C E L A N YA R D
If the battery is low, the
W I T H B E LT C L I P
light will slowly flash red
when off the charging
cradle.
1. Remove the lanyard by twisting and
pulling silver clip.
2. Pull the lanyard and clip away from the
Belle ® device.
3. Press the belt clip onto the back of
Belle as shown until it clicks.
How To Test Your Medical Alert System
We recommend that you test the Mobile System with GPS & Fall Detection
weekly.
1
1.
To test, press and hold the call button and count 1, 2, 3, or until the light
turns blue, then release the button.
2.
After a short delay, you will hear a voice message and then tones or
ringing.
3.
The specialist will answer the call.
4.
Tell the specialist you are testing.
If your Mobile System with GPS & Fall Detection does not test properly, please
call the Galaxy Medical Alert Response Center at 1-855-905-7414 for technical
assistance immediately.
C L E A N I N G B E L L E W E E K LY
Cleaning Your Medical Alert System Weekly
We recommend that you
We recommend that you clean the Mobile System
clean Belle weekly to ensure
with GPS & Fall Detection weekly to ensure proper
charging. Take a soft cloth, such as an eyeglass
proper charging.
cleaning cloth, and gently rub the gold contacts on
the device and charging cradle to remove dirt, oil
Take a soft cloth, such
and debris. You can also spray household cleaner
as an eyeglass cleaning
onto the cleaning cloth (though do not spray
cloth, and gently rub the
directly onto the device or cradle) to remove debris.
gold contacts on the device
and charging cradle to remove dirt, oil and
debris.
You can also spray household cleaner
361 Joffre Place
onto the cleaning cloth (though do not
Windsor, Ontario
Canada N8X 2T1
spray directly onto the device or cradle) to
remove debris.
Rating 5VDC 1A
What you should do
Leave on charger until
battery is charged and the
LED is solid red.
Place device on charger as
soon as possible. On the
charger the light will flash
red every 5 seconds until
the device is fully charged.
2
3
1-855-905-7414
Phone:
www.galaxymedicalalert.com