Autonomic Mirage m-401e Manuel - Page 3

Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} Autonomic Mirage m-401e. Autonomic Mirage m-401e 13 pages. Multi-zone digital amplifier

Imprimer la page

Important Safety Instructions

Read these instructions.

Keep these instructions.

Heed all warnings.

Follow all instructions.

Do not use this apparatus near water.

Clean only with dry cloth.

Do not block any ventilation openings.

Install in accordance with the manufac-

turer's instructions.

Do not install near any heat sources such

as radiators, heat registers, stoves, or oth-

er apparatus (including other amplifiers)

that produce heat.

Use the apparatus only in Moderate

climates. (not in tropical climates)

10. Do not defeat the safety purpose of

the polarized or grounding type plug.

A polarized plug has two blades with

one wider than the other, a grounding

type plug has two blades and a third

grounding prong, the wide blade or the

third grounding prong are provided for

your safety. If the provided plug does not

fit onto your outlet, consult an electrician

for replacement of the obsolete outlet.

11. Protect the power cord from being

walked on or pinched particularly at

plugs, convenience receptacles, and the

point where they exit from the apparatus.

12. Only use attachments / accessories speci-

fied by the manufacturer.

13. Unplug this apparatus during lightning

storms or when unused for long periods

of time.

14. If you install the apparatus in a built-in

installation, such as a bookcase or rack,

ensure that there is adequate ventilation.

Leave 20cm (8") of free space at the top

and sides and 10cm (4") at the rear. The

rear edge of the shelf or board above the

apparatus shall be set 10cm (4") away

from the rear panel or wall, creating

a flue like gap for warm air to escape.

Good airflow is necessary to help ensure

proper operation. Not only should you

provide enough free space around the

unit, but also ensure that air can flow

freely and escape from the amplifier

surroundings. Failure to do so may cause

thermal shutdown of the unit, and

reduced life expectancy.

15. Refer all servicing to qualified service

personnel. Servicing is required when the

apparatus has been damaged in any way,

such as:

a. When the power supply cord or plug

is damaged.

b. If liquid has been spilled, or objects

have fallen into the apparatus.

c. If the apparatus has been exposed to

rain or water.

d. If the apparatus has been dropped or

damaged in any way.

e. If the apparatus does not operate

normally by following the instruc-

tions. Adjust only those controls

that are covered by the operating

instructions.

f. When the apparatus exhibits distinct

change in performance this indicates

a need for a service.

WARNING!

Do not expose the apparatus to dripping or

splashing. Do not place objects filled with liquids

near the apparatus.

WARNING!

To reduce the risk of fire or electric shock, do not

expose this apparatus to rain or moisture.

WARNING!

Equipment must be connected to a Mains socket

outlet with a protective earthing connection.

WARNING!

Never push objects of any kind into the apparatus

through openings as they may touch dangerous

voltage points or short-out parts that could result in a

fire or electric shock.

IMPORTANT!

Ensure adequate ventilation. Do not install in a cabinet

that is smaller than 60cm (24") wide x 45cm (18") deep

x 20cm (8") high. If you do the device may overheat.

Precautions

AC Fuse

The AC fuse inside the unit is not us-

er-serviceable. If you cannot turn on the

unit, contact the dealer from whom you

purchased this unit.

Care

Occasionally you should dust the unit

all over with a soft cloth. For stubborn

stains, use a soft cloth dampened with a

weak solution of mild detergent and wa-

ter. Dry the unit immediately afterwards

with a clean cloth. Don't use abrasive

cloths, thinners, alcohol, or other chem-

ical solvents, because they may damage

the finish or remove the panel lettering.

POWER WARNING: Before plugging

in this device for the first time, read

the following section carefully.

AC outlet voltages vary from country to

country. Make sure that the voltage in

your area meets the voltage require-

ments printed on the unit's rear panel.

e.g. ~ 110V / 240V, 50/60HZ.

The power cord is used to disconnect

this unit from the AC power source.

Make sure that the plug is readily oper-

able (easily accessible) at all times.

If you do not intend to use the unit for

an extended period, remove the power

cord from the AC outlet.

Earth

The unit is defined as Class1 in EN60065

(low voltage directive) and MUST BE

EARTHED. Connect only to a mains socket

outlet with protective earth, and only use

the power cord supplied.

Finland: "Laite on Liitettävä suojamaadoi-

tuskoskettimilly varustettun pistorasiaan"

Norway: "Apparatet må tilkoples jordet

stikkontakt."

Sweden: "Apparaten skall anslutas till

jordat uttag."

Never Touch This Unit with Wet Hands

Never handle this unit or its power cord

while your hands are wet or damp. If

water or any other liquid gets inside

this unit, have it checked by your Auto-

nomic dealer.

Handling Notes

a. If you need to transport this unit,

use the original packaging.

b. Do not leave rubber or plastic items

on this unit for a long time; they

may leave marks on the case.

c. This unit's top and rear panels may get

warm after prolonged use. This is normal.