Gale 3090 Manuel du propriétaire - Page 6

Parcourez en ligne ou téléchargez le pdf Manuel du propriétaire pour {nom_de_la_catégorie} Gale 3090. Gale 3090 12 pages.

Imprimer la page
AP134793 (Koda) Gale 3090 Owners' Manual.qxd
3
POWER
180
0
PHASE
ON
AUTO
4
LINE IN
L
5
R
POWER
ON
6
OFF
6
22/04/2003

Subwoofer Controls

2
1
FREQUENCY
LEVEL
50Hz
150Hz
MIN
MAX
HIGH LEVEL IN
HIGH LEVEL OUT
LEFT
RIGHT
LEFT
RIGHT
+
-
REPLACE WITH FUSE
TO BS4265/IEC127
T2.5A L 250V
3090 SUBWOOFER
Power Rating: 220-240V AC
50Hz
Max Power Consumption:
360W
CAUTION:
RISK OF ELECTRIC SHOCK
DO NOT OPEN
AVIS:
RISQUE DE CHOC ELECTRIQUE
NE PAS OUVRIR
ACHTUNG:
VORM ÖFFNEN DES GERÄTES
NETZSTECKER ZIEHEN
www.gale.co.uk
14:59
Page 6
1. Level
This control allows you to adjust the volume of low frequency output from your
subwoofer amplifier to obtain the best sound-balance within your surroundings.
2. Frequency
This is used to adjust the point at which the crossover will separate the low
frequencies being used by the subwoofer from the higher frequencies played by the
rest of the system. Raising the Low Frequency Cut-Off will increase the frequency
range that the 3090 will reproduce. Lowering the Low Frequency Cut-Off will limit
the range of frequencies reproduced.
7
3. Phase
This allows you to optimise the phase of your 3090 to different listening positions
and that of other speaker systems used at the same time.
4. Power Auto/On
If switched to auto, the subwoofer will remain in standby mode until a signal is
detected at the input. The unit will then automatically switch itself on. It will then
automatically return to standby mode if no input signal is present for approximately
5 minutes. With the switch in the 'ON' position the unit remains permanently on as
long as the main power switch is on. The LED positioned on the rear panel indicates
whether the unit is on or in standby mode (red for standby and green when on).
5. Line Input
If your amplification system has a dedicated subwoofer line output it should be
connected here (see fig.1 opposite).
6. Power Switch
Turns the subwoofer on and off.