Autool HTS 558 Manuel de l'utilisateur - Page 4
Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Autool HTS 558. Autool HTS 558 8 pages. Walnut sand decarbonizing machine
Imprimer la page
(including children) must use the product under the supervision and guidance
of the guardian.
WARNING: In the event of damage to the power cord, plug or other
components, the product must be discontinued and replaced or repaired by the
manufacturer or its maintenance personnel to avoid hazards.
II. Product Introduction
AUTOOL HTS 668 Walnut Sand Decarbonizing Machine is sprayed into the
engine intake pipe through high-pressure airflow, and the high-pressure
high-speed sand will roll and collide in the closed intake pipe, thereby
impacting the carbon deposit on the intake valve and the cylinder wall. Then,
the walnut sand and carbon deposit mixture are recycled to the dust bucket
through a special joint.
III. Operation:
1. Open the package, and check if everything well
2. Please take out the parts and machine, and install it as following:
(1) Connect recovery particle pipe with machine;
(2) Install the push rod fixing bracket in place with the main unit;
(3) Install the push rod with push rod column;
(4) Open the lock switches at both ends of the main unit from the upper end,
and lift the head gently to check if the recovery particle filter is stable;
(5) Check if the filter moves;
(6) After inspection, pour walnut sand with outer diameter 0.4-0.8mm into
the host bucket, 2-4KG particle, preferably not over the height of the sieve;
(7) Gently mount the head back to the main unit and lock both ends of the
lock.
(8) After moving the host to where to use it, connect the compressed air of
not less than 0.7MPa to the host as positioned.
(9) Wear safety goggles to prevent splashing and eye hurt.
(10) Plug into 220V/55Hz power supply.
（11）Connect recovery particle connector into recovery pipe for cleaning
（ 12 ） Press the power switch. To ensure the quality of recycling, it is
recommended to use high-grade sand materials.
（ 13 ） The carbon removal gun is inserted from the injection port on the
recycling granule joint, and the carbon removal switch is triggered to start the
carbon removal process. In order to clean different particles in different