Autopage RS-602 Manuel d'installation - Page 9

Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} Autopage RS-602. Autopage RS-602 16 pages. Professional remote car starter
Également pour Autopage RS-602 : Manuel d'utilisation (8 pages)

Imprimer la page

YELLOW wire

H4. 2 PIN BLUE CONNECTOR FOR THE VALET SWITCH:

Select a mounting location for the switch that is easily accessible to the driver of the vehicle. Mount the valet switch in a

hidden but accessible location. Route the valet switch wires to the control module.

H5. Red, 3-PIN CONNECTOR. – Windshield Receiver /Antenna

The windshield receiver/antenna mounts on the windshield (Inside). We suggest you mount it on the lower left or upper

left-hand side of windshield.

Warning! Do not mount in such a manner that it obstructs the driver's view.

- For Optimum Performance the receiver/antenna whip must be vertical facing up.

- Remove the protective tape backing.

- Carefully align the receiver/antenna and apply to windshield.

- Route the black connector wire behind the trim and connect to receiver/antenna.

- Connect the other end to the control module.

- Special considerations must be made for windshield glass as some newer vehicles utilize a metallic

shielded window glass that will inhibit or restrict RF reception. In these vehicles, route the windshield

receiver/antenna module away from metallic shielded window glass as far as possible.

H6. White 3-PIN DOOR LOCK CONNECTOR:

used in a vehicle that will not unlock with the factory remote while the engine is running, the Lock and Unlock

wires needs to be connected to unlock and secure the vehicle. This is known to be the case in some Toyota and

Lexus models.

NEGATIVE TRIGGER DOOR LOCK SYSTEM

Blue Wire Door Unlock

Green Wire Door Lock

To Exiting

Door Lock Relay

RS-602 REV A.

Matching Resistor

To + 12 V

87a

VATS control Module

Note: If the XT-11 optional Ultra Miniature remote is

( - ) Unlock Pulse

Blue Wire

(+) Lock Pulse

( - ) Lock Pulse

Green Wire

( + ) Unlock Pulse

INSTALL NEW DOOR LOCK MOTOR

Blue Wire

Locking

Master

Switch

+12V

3 Pin

Plug To

Alarm

Green Wire

VAT wire (#1)

VAT wire

Ignition

(#2)

Switch

87a

6/18/2007