Autopage Car-Pro CPX-2200 Manuel d'installation et d'utilisation - Page 2
Parcourez en ligne ou téléchargez le pdf Manuel d'installation et d'utilisation pour {nom_de_la_catégorie} Autopage Car-Pro CPX-2200. Autopage Car-Pro CPX-2200 2 pages.
Imprimer la page
SVMASTER -
CPX-2200 OPERATION MANUAL
TRANSMITTER OPERATION:
Transmitter Button
Feature
Arm / Door lock
Button
Arm and Delete Optional Sensor
–
Button
Car Locator
Button
Panic
Button for 3 seconds
Disarm & door unlock
Button
In or Out Passive mode
Button for 2 seconds
Silent arm / disarm
+
Button
Anti car-jacking
+
Button for 2 seconds
A. ACTIVE ARMING – LOCK & ARM:
1. Press
button on transmitter.
2. The siren chirps once and parking lights flash once indicating the system is now armed. The
vehicle doors will lock upon arming when interfaced with the security system.
DOOR AJAR WARNING: When you arm the system and the siren chirps 3 times, it means you
have left a door or trunk, or hood lid ajar. You should check and find out the defective protecting
point.
SHOCK SENSOR / OPTIONAL SENSOR BY-PASS: Press
arm the security system, by-pass shock sensor connected to 3-pin plug. The system will chirp one
additional time to confirm the sensor bypass mode was activated. The sensor bypass feature is
programmed to activate for one arming cycle only. The security system will return to the original
program setting for the next arming cycle.
SILENT ARMING / DISARMING: Press
+
button together to arm or disarm your security
system. No chirp sound will be heard; arm / disarm confirmation will be through the vehicle's
parking lights only.
B. PASSIVE ARMING
This system is equipped with passive arming feature, which allows the system to arm itself in 30
seconds after the last door is closed; operation is as follows:
1.
Turn ignition to OFF position and exit the vehicle
2.
After all entrances are closed, the system will start counting and LED flashes for 30 sec., if you
re-open any door / trunk / hood the system will stop counting and the LED will stop flashing. It
will start re-counting again once all vehicles' entrances are closed.
3.
After 30 seconds has elapsed, the security system will automatically "ARM". The siren will chirp
once and the parking lights will flash once.
REMOTE PASSIVE:
You can use the remote transmitter to both enter and to exit the passive mode, eliminating the
need to hand your transmitter to parking attendants or garage mechanics.
a). Press and release
button for 2 seconds. The system will enter the passive mode. One
long chirp confirms entry to the passive mode.
b). Press and release
button for 2 seconds. The system will exit the passive mode. Two long
chirps confirm exit of the passive mode.
PASSIVE DOOR LOCKING
The vehicle doors will automatically lock after passive arming cycle has been completed.
C. ACTIVE DISARMING – UNLOCK & DISARM:
Press
button on the transmitter, the siren will chirp twice and parking lights will flash twice to
indicate the security system is now disarmed. The vehicle doors will unlock when interfaced with
the security system.
TAMPER DISARMING: If the alarm has been triggered, upon disarming the system, the siren will
chirp 4 times and the parking lights will flash 3 or 4 times.
AUTO RE-ARM: The security system will auto re-arm itself within 30 seconds after disarming by
remote transmitter. Auto re-arm will be canceled if any protected door has been opened before the
30 seconds timer has elapsed.
PANIC FUNCTION:
Remark
The transmitter can be used as a remote panic switch to manually trigger the alarm in case of
emergency.
Press twice within 3
1. Under the arming mode press and hold
seconds.
the parking lights will flash.
Under arm mode
To stop the panic mode press
If the button is not pressed, the alarm will automatically stop in 30 seconds.
Press & hold 3 seconds
D. TRIGGER THE SYSTEM
When the alarm system is armed, your vehicle is protected as follows:
1.
Light impact will trigger the warn-away signal. A long chirp from siren.
2.
Heavy impact / Door open / Hood open / Trunk open / Turning on the ignition switch; all will
Press & hold 2 seconds
trigger the programmed sequence.
For above (2) The siren and parking light will turn on, alerting of an intrusion for 30 seconds. Then
Under ignition off
it will stop and automatic reset / re-arm. If any one of the sensors or detectors is still active, the
alarm system will sound a maximum of 3 times of 30 seconds cycles. The starter disable relay (if
Under ignition on
installed) prevents the vehicle's starter from cranking.
E. ANTI CAR - JACKING
Warning: If you don't need anti car-jacking function in this alarm system, be sure to set anti car-
jacking feature "DISABLE". This system is default setting all anti car-jacking " DISABLE ".
1). With the Ignition "on", press and hold
The parking light will turn on for 2 seconds to indicate activation of anti car – jacking mode.
2). TRIGGER THE ANTI CAR - JACKING MODE:
3-timer circuits will function as follows:
First timer:
button twice within 3 seconds to
1.
50 seconds after the system has been triggered, the siren will start chirping for 15 seconds.
2.
During this 15 seconds period of chirping, you will be alerted to press and hold
the transmitter for over 2 seconds to turn off the anti car-jacking feature; parking lights will flash
twice and siren will chirp twice confirming success in turning off the anti car-jacking mode.
3.
If not, it will enter the second timer of anti car- jacking feature
Second timer:
65 seconds after the system has been triggered. The siren start sounding and the parking lights
will start flashing.
Third timer:
90 seconds after the system has been triggered
a. The siren will continue sounding and the parking lights flashing, and
b. The starter disable will activate to prevent vehicle from starting.
c. It will remain active until the vehicle's battery power exhausted.
F. DISARMING WITHOUT A TRANSMITTER
The Override function may be used if the remote transmitter is lost or inoperative.
1. Turn ignition switch to 'ON' position and the LED will start flashing, indicating the system has
entered the password override mode.
Once the LED has flashed the same number of times as your password number, then turn the ignition
key "OFF"; the alarm will stop sounding and enter the disarm mode. You can now start and operate
the vehicle normally.
Example: If your programmed Password Code is " 5 " you would;
1.
Turn the ignition switch to the 'ON' position and the LED will start flashing, indicating the system
has entered the password override mode.
2.
Wait until the LED flashes for the 5th time, then the turn ignition key OFF immediately.
The alarm will stop sounding and enter the disarm mode. You can now start and operate the
vehicle normally.
G. IGNITION CONTROL DOOR LOCK.
If the vehicles' door locks have been interfaced to the security system, the system will
automatically lock the vehicle's door when the ignition "ON" and unlock vehicle's door when
ignition "OFF".
SVMASTER -
- http://www.msvmaster.lv
button for over 3 seconds. The siren will sound and
or
button and the panic mode will turn off immediately.
+
button on the transmitter for over 2 seconds.
H. CAR LOCATOR
Under the armed mode press
locator, siren will chirp 6 times and parking lights flash 12
times for you to easily locate your car.
LED INDICATORS:
LED
Function
Off
Disarmed
Slow flash
Armed
Fast flash
Passive arming
CHIRP INDICATORS:
Chirp
Function
1 chirps
Arm
2 chirps
Disarm
3 chirps
Door ajar warming
4 chirps
Disarm / system trigger
6 chirps
Car locator
PARKING LIGHTS:
Parking light
Function
1 flash
Arm
2 flashes
Disarm
3 flashes
Disarm / trigger on ignition or door
pin switch
4 flashes
Disarm / trigger on shock sensor
+
button on
12 flashes
Car locator
ALARM OPERATION CONDITIONS:
Siren
Parking
LED
Light
Arming
1 or 3
1 Flash Slow
Chips
Flash
Disarming
2 or 4
2 or 3 or
Off or
Chirps
4
Fast
Flashes
Flash
Trigger
Alarming Flashes Slow
Flash
Panic
Alarming Flashes Slow
Flash
- http://www.msvmaster.lv
button to activate car
Door
Starter
"CUT"
Locking
On
Unlocking Off
On
On