Galil DMC-30010 Manuel d'installation - Page 7
Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} Galil DMC-30010. Galil DMC-30010 17 pages. Dmc-3xx1 series integrated amplifier
Imprimer la page- 1. Amplifier Installation
- 1. Chapter 1 Overview
- 2. Using this Manual
- 2. Chapter 2 Installation
- 2. Operating Environment
- 2. Mounting Location
- 2. Unpacking the Controller
- 2. Mounting the Controller
- 2. Powering the Controller
- 2. Power Connector
- 2. Motor Connector
- 2. Communication Connection
- 2. Additional Wiring
- 2. Ethernet Connection
- 3. Appendix: Specifications
- 3. Fault Information
Installation
Mounting the Controller
The DMC-3xx1x motion controller must be mounted to a flat surface with 4 – #10 pan head screws
through each mounting hole found on the controller base as shown in Figure 5. If the controller is
mounted on a wall, the controller should be mounted so that the bottom of the controller is horizontal
to the floor (as shown in Figure 5). The enclosure must meet or exceed any fire ratings that are
required of the system as a whole.
With the DMC-3xx12 it should be determined at this time whether or not an additional heat sink will
be required. This is determined based upon the continuous current requirements of the system as
defined in the "Additional Mounting Consideration when using the DMC-3xx12" section above. The
Motor Sizer tool found on our website can be used to determine this value
http://www.galilmc.com/learning/motorsizer.php.
Powering the Controller
The DMC-3xx1x is powered via the DC supply connections. All connectors share a common ground.
The DMC-3xx1x is grounded through the metal enclosure and should be installed on an unpainted
metal surface. The Earth lugs should be used for additional electrical contact.
Figure 5: Mounting the DMC-3xx1x