Autopot AQUAvalve5 1Pot Manuels d'entretien simples

Parcourez en ligne ou téléchargez le pdf Manuels d'entretien simples pour {nom_de_la_catégorie} Autopot AQUAvalve5 1Pot. Autopot AQUAvalve5 1Pot 2 pages.

Imprimer la page

Ensure the silicone is sitting parallel

on the hole below it. Hold at eye level

to check the position is correct

Ensuring that the AQUAvalve5 floods

and drains correctly

Making sure your AQUAvalve5 floods and

drains correctly is simply achieved and

only takes a few seconds.

Hold the AQUAvalve5 at eye level so that

you can see the silicone fitted to the top

float resting on the hole below it.

The silicone must create a tight seal when

touching the hole.

If it looks like it is not sitting parallel on the

hole below, simply lift the top float and

apply pressure to one side of the silicone,

drop the float and hold at eye level again.

Repeat the procedure if necessary.

[email protected] I www.autopot.co.uk I +44 (0)1276 534894

Simple care

guidelines

Care and maintenance

At the end of your growing season, clean

the AQUAvalve5 using warm soapy water.

Using an old tooth brush will help.

The AQUAvalve5 is easily disassembled.

The top float will slide all the way across

and the bottom float is unclipped from its

pivoting position. The circular discs fitted to

the top float can also be removed by using

pliers to grip the raised point.

At this point is it advisable to remove the

silicones to avoid them being lost.

It is also handy to have a paper clip or pipe

cleaner to hand so that you can push it

through the AQUAvalve5 nozzle, this will

remove any lime scale build up that may

have occurred during the growing season.

Blowing through the AQUAvalve5 nozzle

will also help to remove any build up. Do

not under any circumstances use a drill &

drill bit to clear the AQUAvalve5 nozzle.

This

will

potentially

damage

the

AQUAvalve5 beyond repair.

Your 1Pot system

set-up guidelines

[email protected] I www.autopot.co.uk I +44 (0)1276 534894