Dynatech STAR Manuel d'utilisation et d'entretien - Page 13
Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation et d'entretien pour {nom_de_la_catégorie} Dynatech STAR. Dynatech STAR 18 pages. Overspeed governor
Imprimer la pageINSTRUCTIONS: Star Cod: DYN 09.1.19
Date: 14/12/2022 Revision: 19
Dynatech supplies a 6 shaft 500-pulse encoder with the Star plus governor. Model OMRON E6B2CWZ6C500
The encoder's features can be found on the manufacturer's website.
Please contact Dynatech in order to request an Encoder with different pulses.
If needed, the customer may purchase the Star plus governor without an encoder. Please find below drawings
including the measurements required if a customer needs to install an encoder.
6 FIXING
6.1 ATTACHING THE GOVERNOR
The figure on the next page shows governor anchoring points to the lift sling. Marks appear in millimetres.
The governor must be anchored by means of 4 8.8-quality M10 screws. Suitable lengths are between 30 and 40 mm.
Tightening torque must be 80 Nw·m.
It is advisable to use Autoblock nuts in order to avoid possible screw loosening.
6.2 ATTACHING THE TENSORS
The tensors included with the Star limiter can be attached to the pit and the ceiling directly or to the guide rails (see
Note: This manual displays partial information on the instructions for use and maintenance of this product. Please refer to the customer
area in Dynatech's website in order to consult the full manual; http://customers.dynatech-elevation.com/
11