Dynatech V-7000 Instructions pour l'utilisateur - Page 13
Parcourez en ligne ou téléchargez le pdf Instructions pour l'utilisateur pour {nom_de_la_catégorie} Dynatech V-7000. Dynatech V-7000 16 pages. Professional
Imprimer la page
- 1. User Instructions
- 2. Table of Contents
- 3. Safety Precautions
- 4. Introduction
- 5. Front Panel
- 6. Rear Panels
- 7. Inputs
- 8. Outputs
- 9. Speakon Output Connector Assembly
- 10. Operating Modes
- 11. Limiter
- 12. Short Circuit Protection
- 13. Thermal Protection
- 14. Amplifier Features
- 15. Subwoofer and Speaker Setup
- 16. Specifications
Bridge Subwoofer Mode Speaker Set-Up
Use Ch1 Inputs
Do Not Use Ch2 Inputs
Diagram 13
Negative (-) Lead
Use the two red terminal from the banana jacks to
power a subwoofer speaker in mono-bridge mode.
Set to Bridge
Set to Subwoof
PUSH TO RESET
~220V 50Hz
5800 WATTS
Positive (+) Lead
Stereo Subwoofer Mode Speaker Set-Up
Set to Subwoof
Use Ch2 Inputs
Diagram 14
Use either the Speakon or the banana jacks
page 13
Use Ch1 Inputs
Set to Stereo
Set to Subwoof
PUSH TO RESET
~220V 50Hz
5800 WATTS